Layup

Wilsonart International•Temple, TX

2d•Onsite

About The Position

Wilsonart in Temple, Texas has an opening in Assembly for a Layup. The Temple Assembly department currently has an opening for a Layup, grade 1. The Lay-up will assist with the lay-up process under direction of the Layup 2 or 3 team member. Performs designated tasks at the lay-up table assigned by the department Team Lead. This position is for day shift.

Requirements

Knowledge of safety standards applicable to the work area and other pertinent rules/regulations governing work standards.
Knowledge of the material quality standards.
Knowledge of computer sufficient to enter data into the system.
Ability to identify patterns and finishes.
Ability to operate a lift truck and lowboy.
Skill in hand-and-eye coordination.
Ability to operate cut down table.
Lay up material at an adequate pace to match the Layup 2 or 3 performance. (85 – 100 Sheets per hour)
Ability to use a tape measure.
1 year of work experience

Responsibilities

Obtains lay-up material for the run from the pattern pullers, super cutter or sheeting.
Helps with cutting down larger size paper at the cut down table as needed.
Vacuums or brushes off the table before the material is assembled.
Lays up the material according to the assigned lay-up schedule under direction of a Layup 2 or Layup 3 team member.
Monitors for defects in the paper or overlay and verifies length and width of all material laid-up.
Submits request forms for material at the direction of the Layup 2 or 3.
Vacuums and covers the completed run.
Participates in the Lean and Safety process.
Read schedules to help verify material is ready for assembly
Utilize puller screens and pattern Identification screens to look up material and verify runs
Performs other tasks as assigned
Count the proper amount of core material needed for production.