Ironworker- Deer Park, TX
About The Position
Turner Industries is seeking an experienced Ironworker for Project work in Deer Park, TX. This is a non-exempt role that reports to a Direct Supervisor/Foreman. The Ironworker works as a member of a crew to raise, place and unite girders, columns and other structural-steel members to form completed structures and frameworks. Assigned duties are according to specific procedures and work is checked frequently. Successful candidates will have a TWIC card in hand and must be local to the area as there is no per diem or relocation assistance. The schedule is 40 hours plus and subject to change. Candidates must pass a pre-employment background check and health/drug screening.
Requirements
- High school or equivalent
- One (1) to four (4) years of experience in specified skill (depending on mechanic level)
- Knowledge of ironworker tools and how to use them
- Rigging skills including wire rope slings
- Written pre-employment qualification test
- Post-offer drug/alcohol screen and physical evaluation
- Job site safety requirements as required by the client (clean shaven, long sleeves, steel toe boots, etc.)
- Safety equipment as required by the client (hard hat, safety glasses, gloves, respirator, hearing protection, safety harness with lanyard, etc.)
- Applicant/employee must not pose a direct threat to the health or safety of others in the workplace
- TWIC card in hand
Nice To Haves
- NCCER certification is highly preferred
- Some job sites may require NCCER certification
Responsibilities
- Off loads deliveries of structural material from the fabricator.
- Sets up and breaks down hoisting equipment for raising and placing structural-steel members.
- Fastens steel members to cable of hoist.
- Signals worker operating hoisting equipment to lift and place steel member.
- Guides member or rides on member in order to guide it into position.
- Pulls or pries steel members into approximate position while member is supported by hoisting device.
- Forces members into final position.
- Aligns holes in member with corresponding holes in previously placed member.
- Verifies vertical and horizontal alignment of members.
- Bolts aligned members to keep them in position until they can be permanently bolted.
- Cuts steel members to make alterations.
- Perform additional assignments per supervisor's direction.
Benefits
- health
- dental
- vision
- life
- ADD
- voluntary life / ADD
- disability benefits
- leaves of absence
- 401k
- paid time off
- paid holidays
- telehealth access
- employee assistance program
Stand Out From the Crowd
Upload your resume and get instant feedback on how well it matches this job.
What This Job Offers
Job Type
Full-time
Career Level
Mid Level
Education Level
High school or GED
