Inspector Tester C - 1st Shift

Eaton Corporation•Waukesha, WI
•Onsite

About The Position

Eaton’s ES AMER ESS division is seeking an Inspector Tester C to work at its Badger Dr. location in Waukesha, Wisconsin. The role performs assembly inspection and electrical testing of single- and three-phase transformers and regulators at various locations in the assembly plants, following established procedures and monitoring conformance to quality standards. The position’s core hours are 7:00 a.m. to 3:00 p.m. Overtime may extend beyond those hours and may be mandatory. The hourly rate is $24.45. No relocation benefit is offered, and candidates generally must live within 50 miles of the work location; active-duty military candidates are exempt from this geographic restriction.

Requirements

  • High school diploma or GED equivalent from an accredited institution.
  • At least 1 year of manufacturing experience.
  • Ability to work overtime when required.
  • Ability to lift up to 50 pounds and bend, twist, grab, reach, stand, walk, push, pull, and use both hands to lift and lower materials, with or without reasonable accommodations.
  • Eaton does not provide employment immigration sponsorship or support for this position.

Nice To Haves

  • Education in AC/DC fundamentals, completion of electricity coursework from an accredited institution, or at least 1 year of experience in electricity.

Responsibilities

  • Perform routine factory dielectric tests, including induced OX, QC impulse, and applied-potential hipot tests.
  • Perform routine factory load-loss (winding-loss) and no-load-loss (core-loss) tests.
  • Perform power factor, ratio, and resistance tests.
  • Perform operational tests on regulators when required.
  • Perform continuity tests on units.
  • Inspect unit nameplates during routine tests, stamp impedance values on nameplates, and secure nameplates to tested units.
  • Visually inspect the interior of units after testing.
  • Perform minor maintenance of test equipment.
  • Perform special routine tests when required.
  • Visually inspect units throughout the assembly process.
  • Perform required ratio, resistance, leak, continuity, control-box, insulation-resistance, regulator sub-assembly, regulator modification, and regulator run-in tests.
  • Apply decals and stencils to unit exteriors and perform paint mileage checks as required.
  • Assist Engineering and Manufacturing in identifying and resolving shop-floor problems.
  • Complete company forms to communicate inspection status and other information and document inspection results.
  • Collect data as required by established procedures.

Benefits

  • Health benefits available beginning on the first day of employment.
  • Vacation time available beginning on the first day of employment.
  • Up to 12 paid holidays.
  • Weekly pay.
  • Shift premiums of $2.50 per hour for off shifts.
  • Opportunities for overtime.
  • Career progression opportunities to cross-train in different departments and increase compensation.
  • Retirement benefits.
  • Paid parental leave.
  • Educational assistance program.
  • Wellness reimbursement.
© 2026 Teal Labs, Inc
Privacy PolicyTerms of Service