Ice Crafter

CultivaHR•Flower Mound, TX

About The Position

The Ice Crafter is a hands-on production role responsible for all stages of craft ice production, including filling and moving Freeze Chamber Modules (FCMs), harvesting ice, bagging and sealing product, case packing, and palletizing. The position follows quality and safety standards to ensure product quality and consistency while keeping pace with production workflows. Work takes place in production and warehouse areas, with periodic exposure to cold freezer conditions, warm warehouse conditions, moving mechanical equipment, wet or slippery surfaces, and loud noise. Protective equipment includes gloves, hairnets, and composite-toe slip-resistant shoes. Company-provided boots are available; approved personal boots may also be used, and work shoes must remain onsite. No travel is required. The role has no supervisory responsibilities.

Requirements

  • No specific prior experience is required.
  • Ability to follow detailed processes and safety protocols.
  • Team-oriented and dependable, with strong attention to quality and detail.
  • Willingness to work in cold, wet, and noisy environments.
  • Ability to perform the listed duties, including frequent standing, walking, bending, twisting, and lifting up to 70 pounds with assistance.
  • Hand and forearm strength for squeezing and twisting silicone molds.

Nice To Haves

  • High school diploma or equivalent.
  • Experience working in a warehouse and/or production line.

Responsibilities

  • Unload empty FCMs from carts and place them in filler pucks, then load filled FCMs from filler pucks onto carts.
  • Move carts between the fill room, freezers, and harvest room; use a ramp to move carts into and out of freezers, with two people required for this task.
  • Feed full FCMs to the automated harvester and separate silicone from shells.
  • Empty water and waste ice from shells, move shells to the reassembly table, and occasionally remove waste ice blocks using a hammer or the waste tub.
  • Separate ice spheres from silicone using a twisting motion, place spheres in tubs for bagging, and set silicone aside for reassembly.
  • Reassemble FCMs by arranging silicone pieces and sliding the plastic shell over them.
  • Load empty FCMs onto carts.
  • Move tubs of ice spheres to the bagging area and package the correct quantity of spheres in retail or foodservice bags.
  • Replenish bag supplies from storage as needed and visually inspect products for quality and defects.
  • Manually feed filled bags into the heat sealer, verify code-dater printing, and weigh each bag when producing foodservice product.
  • Set up flat cases in the automatic carton erector, pack bags into cases, and move filled cases through the automatic case taper while keeping hands clear of moving equipment.
  • Move finished cases from the takeaway conveyor to small chest freezers, then move cases from the freezers to build pallets.
  • Use a pallet jack to move finished products from the harvest room to the warehouse area.
  • Keep pace with harvesting, bagging, sealing, and case-packing operations.

Benefits

  • Dental insurance
  • Health insurance
  • Health Savings Account
  • Life Insurance
  • Paid Time Off
  • Paid Holidays
  • Vision Insurance
© 2026 Teal Labs, Inc
Privacy PolicyTerms of Service