HC - Trk Driver - Low Boy

Fluor•Buda, TX

13d•Onsite

About The Position

At Fluor, we are proud to design and build projects and careers. We are committed to fostering a welcoming and collaborative work environment that encourages big-picture thinking, brings out the best in our employees, and helps us develop innovative solutions that contribute to building a better world together. If this sounds like a culture you would like to work in, you’re invited to apply for this role.

Requirements

Class A CDL with minimum 3 years articulated experience (tractor trailer combination)
Previous heavy haul experience a plus
Knowledge of FMCSA cargo securement rules
Intricate knowledge of proper methods of loading/unloading and securing loads properly.
Must be experienced with low profile hydraulic detach neck (lowboy) trailers, 3 axle and above, and heavy loads in excess of 15 tons.
Experience with heavy haul/wide loads in urban/suburban traffic without full escort.
Understand and carry out oral instructions
Read and carry out written instructions to perform work tasks
Work at varying heights
Recognize, avoid, and report safety hazards
Assemble and disassemble objects
Operate equipment and power tools
See hazards, safety warnings, and barriers
Bend knees for lifting and routine work tasks
Stoop for work positioning and lifting to perform work tasks
Lift maximum 50 lbs without assistance
Ability to comprehend, and respond to audible/visual instructions, alarms and warnings
Climb/balance on ladders, scaffolding, and structures for work tasks
Kneel for work positioning and work task performance
Reach above shoulders and away from body to perform work tasks
Demonstrate manual dexterity to perform work tasks

Nice To Haves

Previous heavy haul experience

Responsibilities

Follow all health, safely, and environmental requirements
Perform cleanup duties
Perform material handling and storage duties
Identify, use, and care of common hand and power tools
Use and care of craft specific tools and equipment
Knowledge and application of craft related mathematics
Knowledge and use of safety standards and best safety practices relevant to rigging, Inspection of rigging equipment and hardware
Knowledge and application of common hitches, Emergency stop signal, Basic crane hand signals, Knot tying (bowline & clove hitch), and use of rigging equipment relevant to craft specific tasks
Read and use vehicles operator's manual
Identify vehicle safety equipment
Inspect all vehicle systems before start-up
Perform proper vehicle start-up, operation, and shutdown procedures
Perform care and cleanup of vehicle
Perform vehicle inspection, service and maintenance as required
Remain in control and in charge of all loading and unloading of any/all equipment, ensuring load limits (weight, length, height, width) are not exceeded and load is properly secured per FMCSA/DOT cargo securement requirements.
Inspect all equipment prior to loading and following unload.
Operate equipment to load/unload, including dozer, excavator, grader, backhoe, asphalt/concrete paver, rollers, compactors, front end loaders, fork lifts, etc.
Performs operator level inspections and maintenance on assigned vehicles and equipment at start and end of loads and shifts.
Completes all required daily driver log/vehicle inspections along with JSA/STA.
All other duties as assigned.