Foundry Casting Processor- 2nd shift

Eaton Corporation•Syracuse, NY

2d•$20•Onsite

About The Position

Eaton’s ES GEIS CHD division is currently seeking a Foundry Casting Processor- 2nd shift. The core hours are 2:30pm to 11:00pm. The hourly rate for this position is Hourly-$19.77 + $1.50 shift differential per hour.

Requirements

High School Diploma or General Education Development (GED) certificate
Only candidates residing within the immediate area of Syracuse, NY (50 miles) will be considered for this position.
Eaton will not consider applicants for employment immigration sponsorship or support for this position. This means that Eaton will not support any CPT, OPT, or STEM OPT plans, F-1 to H-1B, H-1B cap registration, O-1, E-3, TN status, I-485 job portability, etc.

Nice To Haves

Additional educational or vocational training is a plus but not required.

Responsibilities

Perform a wide variety of duties throughout the foundry areas following standard procedures and/or work instructions.
Duties will involve transporting materials, castings and/or equipment with either a fork truck or payloader.
Use a variety of rough grinding equipment, portable hand power tools and bench grinders as necessary to remove parting lines, gates, riser, flash and other surface defects as prescribed.
Change own small inspect grinding wheels or bits or dress wheels as necessary according to job requirement or when worn, place prescribed wheel or abrasive belt on machine or select wheels or belts within narrow limits.
Operate other power equipment to cut sprues, gates, risers and runners. Operate bandsaw and change blade as required. Operate power vac, repair ladles, dump and shakeout molds, hook off and shovel castings, etc.
Setup and operate automatic molding machines as assigned and/or following work instructions.
Operate shot blast cleaning equipment. Fill small cavities with lab metal and smooth.
Patch surface imperfections within Q.C. standards and operate automatic floor sweeper.
Perform minor maintenance duties such as tightening loose parts (spray nozzles, etc.), replacing parts (sprues, etc.), clean assigned work area.
Detect and report all defective materials; refer questionable cases to proper supervision. Follow prescribed or standard safety regulations.
Complete training as assigned.