Fabricator II (2nd or 3rd)

Enprotech Corp•York, PA

21h•Onsite

About The Position

As a Fabricator II, they will lay out and assemble flat and formed plate components using drawings supplied from engineering with minimal assistance from a Fabricator. Tack welding will be required to join parts as part of the assembly. They will set up fabrication components, lay out and grind parts as necessary to develop shape. Assist as needed in the forming of raw plate. This role is for the 2nd or 3rd shift.

Requirements

GED or High School diploma required.
Three+ (3+) years experience in large structural fabrication.
Proficient in blueprint reading (except geometric tolerancing).
Ability to assemble complex runners with some direction and assistance from a Fabricator 3.
Ability to assemble complex distributor assemblies with some direction and assistance from a Fabricator 3.
Ability to assemble complex shaft to runner installations with some direction and assistance from a Fabricator 3.
Ability to assemble complex Kaplan turbine assemblies with some direction and assistance from a Fabricator 3.
Ability to assemble complex pump assemblies with some direction and assistance from a Fabricator 3.
Ability to set up work cells for effective and efficient operations.
Ability to perform hot and cold forming operations such as buckets.
Ability to generate and implement Lean continuous ideas.
Ability to vent check runners and pumps with assistance and direction from Fabricator 3.
Ability to operate main cranes and make lifts of components up to 25 tons.
Detail oriented.
Ability to problem solve.
Ability to work in teams and independently.
Ability to communicate effectively.
Proficient in blueprint reading.
Ability to follow safety procedures.
Ability to assemble complex runners with some direction and assistance from a Fabricator I.
Ability to assemble complex shaft to runner installations with some direction and assistance from a Fabricator I.
Ability to assemble complex Kaplan turbine assemblies with some direction and assistance from a Fabricator I.
Ability to assemble complex pump assemblies with some direction and assistance from a Fabricator I.
Ability to make roll set ups, mount weldments on to welding positioners.
Ability to perform hot and cold forming operations such as buckets.
Ability to generate and implement Operational Excellence initiatives.
Ability to vent check runners and pumps with assistance and direction from Fabricator I.
Ability to operate main cranes and pumps with assistance and direction from Fabricator I.

Nice To Haves

Training from college or technical school.
Hydro Fabrication experience a plus.

Responsibilities

Layout and assemble flat and formed plate components using drawings.
Tack weld parts as part of the assembly.
Set up fabrication components.
Lay out and grind parts as necessary to develop shape.
Assist in the forming of raw plate.
Accurately interpret instructions, prints, and work orders.
Read and record measurements using conventional micrometers, calipers, and related instruments.
Keep equipment and work area clean and orderly.
Keep supervisor informed of problems regarding work piece, schedule, safety, etc.
Paint equipment and job parts.
Assemble finished machined parts to prove fit and for the purpose of further machining.
Perform hot and cold forming operations such as buckets.
Generate and implement Lean continuous ideas.
Vent check runners and pumps with assistance and direction from a Fabricator 3.
Operate main cranes and make lifts of components up to 25 tons.
Make roll set ups, mount weldments on to welding positioners.