Engineering Technician II

Parsons Corporation•USA NV (Field), NV

18d•$16 - $71

About The Position

The SCA – Engineering Technician serves as an experienced field technician supporting the Federal Aviation Administration under Parsons’ TSSC-5 contract. The role performs installation, modification, testing, troubleshooting, repair, and preventive maintenance on electronic systems and equipment supporting the National Airspace System. Work may involve navigation aids, communications systems, surveillance and support systems, and associated power, grounding, and control equipment. The technician works under limited supervision, following established procedures, technical documentation, and FAA directives. They may independently complete routine or moderately complex tasks and support senior technicians or engineers with more complex systems and activities. The position also supports field installations and site work, documents completed work, maintains and uses test equipment, and follows applicable safety, security, configuration control, and quality procedures. Travel of up to 100% within the United States may be required.

Requirements

High school diploma.
Five or more years of working knowledge of basic analog and digital electronics.
Five or more years of working knowledge of fundamentals of RF and communications equipment.
Five or more years of working knowledge of standard electronic test equipment, including digital multimeters, basic oscilloscopes, and signal generators.
Ability to read and interpret basic schematics, wiring diagrams, and technical documentation.
Ability to follow written and verbal instructions and standard procedures.
Ability to work safely in field, shop, and facility environments.
Basic Microsoft Suite, Internet, and email skills.
Must be able to meet customer security requirements; a background check by federal authorities will be performed.
Must be able to travel up to 100% within the USA.
May require repetitive movement, including lifting up to 50 pounds, bending, and standing.

Responsibilities

Install, relocate, and remove electronic systems and equipment, including navigation aids, communications systems, surveillance and support systems, and associated power, grounding, and control equipment.
Troubleshoot and repair systems to the unit, board, or module level using test equipment and established troubleshooting guides, fault-isolation procedures, and technical manuals.
Escalate complex or recurring issues to the crew lead, FAA counterparts, and project management.
Read and work from schematics, wiring diagrams, interconnect drawings, equipment manuals, technical orders, job plans, FAA orders, work instructions, and site-specific procedures.
Support pre-installation checks and site preparation.
Install racks, cabinets, and equipment according to drawings and installation standards.
Route, terminate, label, and test coax, fiber, and copper cables under guidance.
Assist with system power-up, basic alignment, and functional testing.
Configure and operate standard electronic test instruments; perform basic measurements, alignments, and performance checks; and maintain calibration and handle equipment according to procedure.
Complete maintenance logs, service tickets, and test forms; record parts used, corrective actions, and test results; and provide redline/as-built information to senior technicians or engineers.
Comply with FAA and Parsons safety policies, OSHA regulations, and site Risk Management Plans.
Adhere to physical and information security requirements at FAA facilities and follow configuration control and quality assurance procedures.
Collaborate with senior technicians, engineers, project managers, and FAA representatives to support project objectives.