Electrician Maintenance Project Crew - All Shifts - RVI Scranton

Tyson Foods•Scranton, AR

1d•Onsite

About The Position

This role is for an Electrician Maintenance Project Crew member responsible for maintaining electrical systems in a plant environment. The position requires a comprehensive understanding of various electrical systems, including AC motor and DC drive systems, and the ability to work with schematics. The role also involves troubleshooting, maintenance, and installation of electrical components, as well as assisting with various project-related tasks that may include welding, hydraulics, power transmissions, pneumatics, fabrication, pipe fitting, rigging, mechanical layout, and plumbing. The job also entails operating heavy industrial equipment and performing other duties as delegated by management to ensure the plant's welfare and operational efficiency. A strong knowledge of safety codes and procedures is essential.

Requirements

Electrician Maintenance EC01 – EC08.
1 plus year of accumulative electrical or industrial maintenance or millwright experience required.
Good working knowledge of all OSHA, NEC Codes and Plant Safety Policies and Procedures.
Complete understanding and working knowledge of 110, 240, 480-volt AC motor and DC drive system.
Ability to read and work off schematics.
Ability to use all electrical hand tools.
Ability to weld, use cutting tools such as cutting torch, plasma cutter, grinders, etc.
Ability to operate heavy industrial equipment such as crane, boom lift, scissor lift, telehandler, forklift etc.
Fabrication experience to build catwalks, handrails, transitions, equipment supports etc.
Rigging experience/certifications.
Ability to climb stairs and ladders.
Ability to lift more than 60 lbs.
Ability to read and understand policies, procedures and regulations.
Ability to document information.
Ability to communicate with others written and verbally.

Nice To Haves

Skills in Welding, Hydraulics, Power Transmissions, Pneumatics, Fabrication, Pipe Fitting, Rigging, Mechanical Layout and Plumbing will be needed to assist in projects.
Suitable knowledge of removal, installation, and setup of rendering equipment, to include but not limited to conveyors, pumps, cookers, hydrolyzers, presses, power transmission components, steam traps, ramps, catwalks and piping.

Responsibilities

Maintain and troubleshoot electrical systems in the plant.
Install and replace conduit.
Estimate and design basic electrical systems.
Perform welding, cutting, equipment removal and installation, structural fabrication, pipe fitting, and heavy equipment set up.
Operate various electrical and pneumatic power tools and equipment, including cranes and lifts.
Remove, install, and set up rendering equipment such as conveyors, pumps, cookers, hydrolyzers, presses, power transmission components, steam traps, ramps, catwalks, and piping.
Ensure compliance with OSHA, NEC Codes, and Plant Safety Policies and Procedures.
Calculate and determine wire and pipe sizes.
Line up pipe runs.
Calculate estimated completion times.
Perform basic electrical work and use basic electrical tools including a digital multi-meter, wire/unwire 3 phase motors, and basic single-phase terminations.
Operate heavy industrial equipment such as crane, boom lift, scissor lift, telehandler, forklift.
Perform fabrication to build catwalks, handrails, transitions, and equipment supports.
Perform rigging.
Climb stairs and ladders.
Lift more than 60 lbs.
Read and understand policies, procedures, and regulations.
Document information.
Communicate with others written and verbally.
Perform any/all other duties to maintain the welfare of the plant.
Perform other duties assigned by Supervision.