Electrician Craftsman 2

Kiewit•Abilene, TX

About The Position

Plan, lay out, install, test, and repair wiring, electrical fixtures, apparatus, motors, equipment, and control systems in accordance with applicable plans, specifications, codes, and industry standards. This is an intermediate-level position in a construction or industrial setting, including work with high- and low-voltage systems.

Requirements

Experience as an electrician in a power plant or industrial setting.
Working knowledge, skills, and abilities for the position.
Ability to understand, follow, and transmit written and oral instructions and communicate effectively with management and supervision.
Ability to use hand tools, power tools, and layout tools safely and efficiently.
Must have required tools.
Ability to pass pre-access drug and alcohol testing and a fit-for-duty medical examination.
Ability to perform the physical and site-related requirements described, including moving around construction or industrial sites; accessing work areas using ladders, mechanical platforms, manlifts, or scaffolds; working in confined, cluttered, uneven, noisy, and dusty environments; and moving items weighing up to 50 pounds.

Responsibilities

Interpret drawings, sketches, software, and plans, and determine appropriate work procedures, tools, and equipment to troubleshoot and repair problems.
Measure, cut, bend, thread, assemble, and install electrical conduit; weld supports; install cable and duct banks; and make terminations.
Install and fasten control and distribution apparatus in place.
Test and start up systems and check circuit continuity to ensure electrical compatibility and component safety.
Observe installed equipment or systems in operation to identify hazards and determine whether adjustments, relocation, or replacement are needed.
Pull wire through conduit and connect wiring to lighting fixtures and power equipment, as required.
Work with high- and low-voltage systems.
Disassemble and repair defective electrical equipment or systems.
Operate electrical and mechanical hand tools and power, hydraulic, pneumatic, and electrical tools.
Observe and comply with safety and project rules, and perform other duties as required.