CNC Router Operator

Ethan Allen•Maiden, NC

1d•Onsite

About The Position

This role involves operating a CNC router to cut plywood sheets according to work orders. Responsibilities include material handling, machine operation, material preparation, cleaning, and basic maintenance. The operator will use various tools and equipment, including a suction lift, forklift, and cleaning tools. The position requires attention to detail, the ability to follow instructions, and physical capability to handle materials.

Requirements

Ability to read and follow directions (verbal and written)
May require basic math skills: counting, adding and subtracting
Ability to lift up to 50lbs
Previous experience preferred

Responsibilities

Use suction lift to move plywood sheets to milling board on table for inspection and prep prior to loading the router.
Slide plywood sheet and milling board from roller table to router and fit into place.
Load/Select work order on touch screen and initiate cut.
Pull cut parts and stack on frame buggy.
Break up plywood scrap and place in scrap buggy, then sweep floor around work area/CNC.
Push frame buggy to line up and push scrap buggy when 1/2 full to grinder conveyor and dump scraps.
Roll milling board through vacuum system to remove dust and then slide board back to inspect/load table.
Clean router table using air restricted blow gun and/or vacuum to remove excess dust.
Use forklift to restock plywood sheets by picking up a hack of plywood (35 sheets) from stock and take it to router.
Perform weekly clean-up by hitting the “E” Stop switch and climbing on machine to wipe down.
May perform other duties/ special or non-routine assignments as instructed.