Assembly Operator

AAM - American Axle & Manufacturing • Newton, NC

1d • Onsite

About The Position

Assembly Operator in an automotive manufacturing environment.

Requirements

• High school diploma/ GED

Nice To Haves

• Modify CNC programs for 2 technologies
• Operate/inspect Hoist-if applicable
• Perform autonomous maintenance-if applicable
• Rotate to other cells-if applicable
• Train in principle skills ( LELC )

Responsibilities

• Understand lock out/ tag out procedures
• Keep machine and work area clean and organized
• Perform specific safety procedures on equipment safety in cell/line/dept./plant
• Report safety issues
• Meet or exceed department safety goals
• Wear personal protective equipment
• Meet or exceed Cell and Department quality and Plant goals
• Understand / document all quality requirements per process
• Master all process gauging
• Identify / segregate discrepant material
• Document and maintain DMR areas
• Read and interpret all charts, print outs and pre ops
• Perform 1st piece inspection using setup verification sheet
• Read and interpret standardized work / process plans
• Use computer equipment to enter and receive data
• Report maintenance problems using the work order System
• Understand, document and maintain maintenance and pre-op checklist
• Understand and verify machine verification log / daily checks
• Use FIFO and visual floor management at each process
• Meet or exceed daily production goal / schedule
• Adjust machine settings and troubleshooting-as applicable
• Apply statistical methods-as required
• Apply tooling requirements, sheets, life standards, changes and off-sets
• Operate/inspect Hoist-if applicable
• Perform autonomous maintenance-if applicable
• Rework, scrap and non-conforming material process-as required
• Rotate to other cells-if applicable
• Participate in team meetings
• Promote a teamwork environment
• Support team (active and constructive role)
• Understand dept. responsibilities and roles
• Monitor tool life, notify supervisor/process engineer of issues and / or missed goals
• Modify CNC programs for 2 technologies
• Communicate effectively at shift change
• Communicate effectively with team and supervisor
• Understand department responsibilities and role
• Understand and maintain hourly production boards
• Train in principle skills ( LELC )
• Understand, apply and react to SPC measurements
• Confirm all shop order confirmations in SAP
• Understand and perform packing as required
• Comply with assigned work schedule

What This Job Offers

• Job Type: Full-time
• Career Level: Entry Level
• Education Level: High school or GED