Assembler B-2nd shift

Eaton Corporation•Los Angeles, CA

6d•Onsite

About The Position

Eaton’s IS AER FMC division is hiring an Assembler at its Los Angeles, California facility. The role assembles and tests mechanical assemblies, subassemblies, and top assemblies ranging from routine to complex, including commercial aerospace products. It may also involve occasional electrical assembly and soldering, unusual work without standard processes, and acceptance testing of repaired, modified, returned, or production units. The position requires little to no supervision and may involve working with Manufacturing and Quality Engineering to implement assembly and test procedures.

Requirements

High school diploma or GED from an accredited institution.
At least 2 years of assembly experience in a manufacturing, aerospace, or military environment.
At least 2 years of experience testing mechanical, hydraulic, pneumatic, or electromechanical assemblies.
Must meet the U.S. person requirement for access to export-controlled information: U.S. citizen or national, U.S. lawful permanent resident, refugee, or asylee.
Ability to read assembly blueprints, wiring diagrams, and testing schematics.
Working knowledge of shop test equipment and testing procedures, with the ability to test various assemblies and subassemblies.
Ability to use inspection gauges, multimeters, force scales, torque wrenches, and production test equipment.
Ability to follow written and verbal instructions.
Ability to cross-train on a variety of hardware and subassemblies.
Ability to communicate and interact effectively with other departments and organizations, and record data to support process-improvement ideas.
Ability to push, pull, and lift up to 25 lbs.
Computer proficiency and attention to detail.
Willingness to perform repetitive tasks while sitting or standing for extended periods.
Must reside within 50 miles of Los Angeles, California; relocation benefit is not offered.

Nice To Haves

Six years of experience in aerospace manufacturing.
Associate degree in a technical field.
Experience working in an FAA environment.
Working knowledge of Eaton production units or similar electromechanical products and ability to retain knowledge of units produced.

Responsibilities

Assemble and test mechanical assemblies, subassemblies, and top assemblies, using appropriate tooling and documentation.
Organize data and prepare test reports.
Perform lock wire or safety wire work and install nameplates.
Visually inspect items, identify defects, and handle them according to established procedures.
Prepare materials, including lapping surfaces with appropriate tooling techniques and compounds.
Cross-train when required.
Identify and assist with process improvements.
Perform acceptance tests on repaired, modified, returned, or production units, including in-person testing as required.
Determine when an Engineering Change Order (ECO) is required and may work with Manufacturing and Quality Engineering to implement assembly and test procedures.
Represent the department during customer audits or visits when requested.
Use test equipment for in-process testing and final Acceptance Test Procedures (ATPs).