Assembler (Stacker) - 1st Shift

Eaton Corporation•Waukesha, WI

1d•$24 - $28•Onsite

About The Position

Eaton’s Electrical Power Systems Division is seeking an Assembler (Stacker) – 1st Shift to join their team. This position is based at their Lincoln Avenue facility in Waukesha, WI. The core hours are 5am – 1pm, Monday-Friday, with potential for overtime that may be mandatory at times. The role involves assembling coils, steel cores, and clamps for transformers, setting up stack tables, stacking steel according to specifications, and welding core clamp assemblies.

Requirements

Must have a High School diploma or GED (General Education Degree) from an accredited institution
Candidates must be legally authorized to work in the United States without company sponsorship, now or in the future.
Ability to use electronic measuring devices.
Ability to operate machines and manual assembly
Ability to lift and carry up to 50 lbs. with or without reasonable accommodation.
Ability to work overtime when required.

Nice To Haves

Minimum of one (1) year of electrical experience.

Responsibilities

Follows bills of material required for core steel assemblies to be cut.
Closely monitor automatic shearing of steel while simultaneously stacking on stack table.
Monitor core steel for burr level, correct sizing, and proper stacking.
Set up fixture on the stacking tables for proper high precision core alignment.
Stack the main core and up-ends completed unit onto a roller cart.
Install coils and insulation into main core and stack top yoke.
Assemble and weld core clamps into position.
Move materials and completed assemblies using a forklift and overhead crane as required.
Review for the quality level of edge burrs. Decide on when to change blades and schedule work with the supervisor.
Maintain awareness of steel slit edge burr.
Watch for waviness of steel after shearing. Identify reasons for steel slit edge waviness (possible bad bearing or defective core steel). Inform supervisor when problems occur. Work with supervisor and maintenance to resolve the problem.
Operate and set up stacking table, tilt table, and base plate.
Completes proper core lacing.
Install top and bottom clamp with end plates.
Operate horizontal shear and vertical band saw.