Tool Crib Attendant (2nd Shift, Mon-Fri, 2:30 p.m.-11:00 p.m.)

CTC GLOBAL CORPORATION•Irvine, CA

10d•$21 - $21•Onsite

About The Position

The Production Tooling Technician must have knowledge of the Core Production department; will be responsible for the assigned tasks in the production tooling area, including but not limited to: cleaning/polishing, tooling inspection, machine set-up and tear down tooling in production on the job site and will be responsible for layout and fabrication of all tooling of Core production.

Requirements

High school diploma or general education degree (GED), or equivalent combination of education and experience.
Mechanical aptitude.
Use of hand and power tools.
General machine shop principles.
Ability to speak, read and interpret documents and blueprints, such as safety rules, operating and maintenance instructions, and procedure manuals.
Ability to write routine reports and correspondence.
Ability to effectively present information in one-on-one and small group situations to employees.
Regularly required to stand and walk and use hands to finger, handle and feel.
Frequently required to reach with hands and arms; climb and or balance; stoop, kneel, crouch, or crawl and talk and hear.
Must regularly lift and/or move up to 30 pounds and occasionally lift to 50 pounds.
Ability to start and stop pultrusion tooling production equipment.
Operate powered industrial equipment.
Operate software for tracking preventive maintenance.
Ability to read and interpret gauges and record measurements.
Ability to read and interpret safety rules, SDS (Safety Data Sheets), operating and maintenance instructions, and any relevant manuals.
Ability to stand for an 8-10, with an occasional 12-hour shift.
Use of hands and arms to lift, handle, clean, install, and position materials and tools/machinery, and to otherwise manipulate things.
Working knowledge of hand and power tools to achieve tight tolerances and machined finishes crucial to composite lay up.

Nice To Haves

Knowledge of all pultrusion tooling and calibration of same.
Good communication, numeric aptitude, attention to detail skills.
Knowledge of all Tooling area documents and paperwork including core production set-up sheets, testing request forms, and work orders.

Responsibilities

Perform safety inspections, procedures and regulations, scheduled maintenance, and equipment change-over (tear down and set-up).
Ensure strict adherence to corporate values in complying with all company environmental, safety and other laws and regulations.
Coordinate daily and outage-related work to support and maintain unit availability.
Check, re-check, and check again tooling inspection reports for compliance reliability.
Troubleshoot tooling equipment, document discrepancies, and write work orders.
Monitor and document after cleaning, inspecting Dies, Carbon bushing, and other tooling.
Notify a qualified individual of any discrepancies of tooling.
Observe and be attentive to machine and all tooling to detect and prevent possible malfunctions.
Recognize and alert supervisors of anything unusual.
Effectively execute shift change by preparing and cleaning all tooling, equipment and supplies to minimize down time.
Inform the incoming shift of any special instructions or changes.
Read and interpret gauges, record measurements, and document all information accurately.
Follow operating and maintenance instructions for tools/machinery, and utilize relevant manuals for adherence to standard operating procedures.
Maintain a safe work environment and thoroughly understand the Safety Data Sheets (SDS) for the proper handling of materials.
Operate and maintain calibration for Air gage (Western Gage Co) and Bore Scope.
Maintain inspection reports to track wear/usage of pultrusion dies and determine end of life of composite tooling.
Maintain, clean, refurbish, and in some cases, fabricate over 5,000 individual pieces in the Tooling department.
Instrumental in weekly/biweekly machine setups for production.
Video characterize and capture visual defects in Pultrusion dies up to a 48” cavity.