Tester - 1st Shift

Eaton Corporation•Glenolden, PA

1d•Onsite

About The Position

The Tester is responsible for testing electro-mechanical products for compliance to Acceptance Test Procedures (ATPs) and customer/internal drawings. They work with PMO, as needed, for customer witness test.

Requirements

High School Diploma or GED equivalent from an accredited institution.
Minimum of 2 years of experience in electro-mechanical environment.
Must be a U.S. person, defined as a (i) U.S. citizen or national, (ii) U.S. lawful, permanent resident (green card holder), (iii) refugee under 8 U.S.C. 1157, or (iv) asylee under 8 U.S.C. 1158.
Understanding basic pressure theory
Understanding of electronic theory. Basic understanding of Ohm’s law and the relationship between resistance, current, and voltage.
Capable of measuring resistor components with multimeter
Ability to perform ATP product testing using Labview programming interface and test racks.
Knowledge of High and Low pressure test vessels and safety precautions when working
Proper use of Mil-Spec oils and gasses
Basic Electronics and Mechanical Theory in relation to PC Board troubleshooting

Nice To Haves

Associates or Technical Degree in Electronics or a related field from an accredited institution.
2+ years of electronic testing experience in a manufacturing environment.
When an assembly fails resistance at in process or final test the employee should be capable of diagnosing and recommending fixing, where applicable, in most cases.

Responsibilities

Verify product compliance to Acceptance Test Procedures (ATP) / drawings and maintain accurate ATP records
Utilize test fixtures and test equipment including oscilloscopes, function generator, device programmer, mass spectrometer, vibration table, tenney chamber, hot oil room, etc. to perform ATP.
Troubleshoot and diagnose common failure modes when test failures occur.
Inspect and diagnose PC Boards to component level (for failure analysis)
Work from work orders, engineering drawings, and visual/written work instructions to assemble electro- mechanical components.
Coordinate with Engineering group for shared resources and test validation
Identify and initiate continuous improvement for product safety, quality, and efficiency.

Benefits

Health insurance
Vacation time
Up to 13 Paid Holidays
Plant shutdown between Christmas and New Year’s
Retirement benefits
Paid Parental Leave
Educational Assistance
Wellness Reimbursement
Monthly fresh fruit and pretzels
Fun onsite events hosted by our activity, wellness, and community involvement teams.