Tester

Vestas•Brighton, CO

2d•Onsite

About The Position

The Tester is responsible for testing electronic components of Nacelle before final assembly occurs. This role involves controlling and testing assembled or pre-assembled products in production, ensuring adherence to quality standards, and performing assembly or process work as needed. The position also requires problem-solving to diagnose test failures, acting as a point of contact for engineering changes, and ensuring compliance with order specifications and quality control systems. Additionally, the Tester will be responsible for QDA entry, making NCR reports, and providing customer service. Safety is paramount, given the high hydraulic pressures and high voltages involved in testing.

Requirements

Journeyman or Master Electrical license and 4 years' hands-on experience OR documented electrical education (i.e. Associates degree in Electrical Engineering, Trade school certificate of graduation, Bachelor's degree in electrical engineering) and 4 years' hands-on experience
Experience must be with industrial or commercial electrical equipment including maintenance and troubleshooting 3 phase systems and controls.
Annual refresher courses in electrical and hydraulic safety training
Knowledge of Manufacturing software and Spreadsheet software
Ability to add, subtract, multiply, and divide in all units of measure, using whole numbers, common fractions, and decimals
Ability to compute rate, ratio, and percent and to draw and interpret bar graphs
Ability to understand and carry out instructions furnished in written, oral, or diagram form
Ability to deal with problems involving several concrete variables in standardized situations
Ability to read, write and comprehend simple instructions, short correspondence, and memos
Ability to observe safety and security procedures

Responsibilities

Testing safely is the #1 priority as there are high hydraulic pressures and high voltages in test
Control and test an assembled or pre-assembled product in production and complete quality control to ensure no failures pass through to the next level and/or supplier
Verify adherence to Vestas quality and testing standards before allowing product to take to next operation
Perform assembly / process work in operation as needed
Problem-solving by trying to diagnose test failure issues
Point of contact within operation for process/product engineering changes
Ensure NCR reports are made
Inspect product to determine compliance with order specifications and company's quality control system
QDA entry; stamp mark of approval or rejection with QDA on product and write report
Provide customer service by responding to requests for service and by listening and obtaining clarification when needed
Observe safety and security procedures; determine appropriate action beyond guidelines; report potentially unsafe conditions; use equipment and materials properly
Other duties as assigned