Tester II - 2nd Shift

Eaton Corporation•Irvine, CA

6d•Onsite

About The Position

Eaton’s IS AER FMC division is currently seeking a Tester II - 2nd Shift. The hourly rate for this position is $25.00 + $1.00 shift differential per hour. The hours for this shift are 2:00 pm - 10:30 pm. This position is also eligible for a variable incentive program. Salaries are based upon candidate skills, experience, and qualifications, as well as market and business considerations. The Tester is responsible for performing bench testing of a diversified line of parts, subassemblies and completed units following established procedures.

Requirements

Must have a high school diploma or GED from an accredited institution.
Minimum of three (3) years’ work experience in Fuel, Hydraulic and/or Pneumatic Testing is required
Knowledge of simple math including the use of addition, subtraction, multiplication, and division of whole numbers
Ability to use direct reading and fixed gauges
Able to read blueprints and schematics
Detailed Oriented
Works Independently
Continuous Improvement
Follow Safety Practices & Procedures
Ability to lift up to 50lbs
Must be a U.S. person, defined as a (i) U.S. citizen or national, (ii) U.S. lawful, permanent resident (green card holder), (iii) refugee under 8 U.S.C. 1157, or (iv) asylee under 8 U.S.C. 1158.

Nice To Haves

Previous work experience in either the Aerospace, Automotive, and/or Airline Maintenance industries

Responsibilities

Perform bench work requiring use of simple limit direct reading gauges and meters
Build / fabricate own setup operations on less complicated test systems
Connect products to be tested to test equipment, monitor gauges and meters, verify and record results
Comply with all safety requirements, including proper use of personal protective equipment and operation of equipment in a safe and competent manner. Understand and meet all departmental safety objectives and goals.
Keep assigned work-area clean, organized, and orderly per 5S standards.
Perform Lean Initiatives including Continuous Improvement
Lead and interpret blueprints & schematics