Struct & Payload Design Engr (Structural Design)

Boeing•Everett, WA

9d•Onsite

About The Position

Boeing Global Services (BGS) is currently seeking a Structures Design Engineer (Level 2 or 3) to work at our Everett, WA location. This is a great opportunity to work in the Commercial Airplanes Washington Design Center. Our teams are currently hiring for a broad range of experience levels including Experienced and Career Levels - Struct & Payload Design Engr (Structural Design). This position is expected to be 100% onsite. The selected candidate will be required to work onsite at the Everett, WA facility. In this role, you will be focused on the evaluation of in-service (fleet) performance of the landing gear, evaluation for wear and corrosion, and establishing a technical basis supporting maintenance and overhaul. This role will involve working with Customer Support Engineering, Operator/Customers, and Maintenance and Repair Organization (MRO) providers. There is the potential for international travel. The Landing Gear Design Center is responsible for the full life cycle of landing gears from product development through post-production, across all BGS programs. Assigned work may evolve over time.

Requirements

2+ years’ related work experience in design
Bachelor's Degree or higher in one of the following engineering majors: Mechanical, Aerospace, Aeronautical, or Civil, and select Structures degrees
Experience with Engineering classification such as Mechanical, Aerospace, Civil or Structural Engineering
This position must meet Export Control compliance requirements, therefore a US Person as defined by 22 C.F.R 120.15 is required. US Person includes US Citizen, lawful permanent resident, refugee, or asylee.

Nice To Haves

5+ years’ related work experience in design
Experience in preparing and releasing product definition data (PDD), using CATIA V5, PDM ENOVIA, etc.
Experience working with Boeing Factory, Boeing Fabrication Division, and/or producers of parts within the supply chain.
Experience in post-production products/customer support

Responsibilities

Coordinates with Customer Support Engineering, Operator/Customers, and Maintenance and Repair Organizations (MRO) for collection of data during landing gear overhauls
Evaluates data for wear, corrosion, and other damage to determine overall landing gear in-service performance
Predicts landing gear in-service performance for varying overhaul intervals
Recommends changes in maintenance practices to improve landing gear in-service performance, where necessary
Works under general direction.