Staff Engineer, Manufacturing DFA

Celestica International LP • Austin, TX

23d

About The Position

The Staff Engineer, Manufacturing Process runs the assembly and serviceability screen within design. The role models assembly sequences, checks access, tool clearance and handling, and raises findings before mechanical designs are committed. The engineer also supports trial builds and mechanical issues at the assigned site.

Requirements

• Four to eight years in mechanical, assembly, or NPI engineering with system integration exposure.
• CAD proficiency.
• Degree in mechanical engineering.
• Typical experience is 7 to 10 years of related experience; experience in similar job roles.
• Bachelor's degree or an equivalent combination of education and experience may be considered; educational requirements may vary by geography.

Responsibilities

• Run pre-DFA on assigned platforms and issue reports before release.
• Model assembly sequences and check interference, fastening, routing, and service access.
• Log findings with severity and route them, and work on dispositions with mechanical and industrial design.
• Support trial builds at the assigned site and capture assembly cycle time and operator-induced defect modes.
• Support rack integration and answer thermal and cold plate assembly questions for the assigned site.
• Propose DFA rule changes based on recurring findings and field service data.

What This Job Offers

• Job Type: Full-time
• Career Level: Senior