Set-Up, Die

Magna International•Newaygo, NE

About The Position

The Set-Up, Die position changes molds, dies, and fixtures in accordance with local procedures, including minor tool repairs or insert changes. The role documents changes, adjusts processes, and involves appropriate resources when processes are outside established parameters. It supports machine start-up and shutdown, checks that subsystems are operational, and assists with maintenance of molding machines, robots, hydraulic pumps, gauges, heaters, and auxiliary equipment. The position also performs weekly and monthly preventive maintenance on molds and fixtures; changes Butyl, Nitrogen tanks, and Urethane; runs soft seals for HWN and HWS; and conducts daily tool cleaning and seal replacement. Additional duties include housekeeping, 5-S and maintenance in chemical storage areas, and maintaining adhesives storage/FIFO, day tanks, and primer levels. The employee follows safety and hazardous-waste procedures, including lockout procedures, inspects parts after changeovers, checks parts against process control sheets, communicates equipment and schedule information, and may train other staff. The role is regular/permanent.

Requirements

  • High school diploma or equivalent and ability to learn quickly.
  • Basic math and reading skills, including decimals, fractions, and geometry.
  • Demonstrated mechanical aptitude, including ability to set up equipment.
  • Ability to read and interpret blueprints and schematics.
  • Knowledge of materials used in processes.
  • Hi-lo license or ability to obtain a Hi-lo license.
  • High degree of manual dexterity.
  • Ability to lift 40 pounds or more; safety requirements also specify the ability to lift 50 pounds.
  • Good communication and interaction skills, with ability to work without direct supervision.
  • Demonstrated problem-solving skills and ability to troubleshoot processes and equipment.
  • Basic knowledge of computers, equipment, tools, and job-related paperwork, including standard work, in-process control sheets, and customer-driven quality requirements.
  • Minimum 2 years of setup experience.
  • Ability to operate an overhead crane.
  • Ability to have full range of motion in the neck and shoulders, twist and bend consistently, work overhead, and access small spaces.

Responsibilities

  • Change molds, dies, and fixtures according to local procedures, including minor tool repairs and insert changes.
  • Document changes and adjust processes or involve appropriate resources when adjustments fall outside established parameters.
  • Perform weekly and monthly preventive maintenance on molds and related fixtures.
  • Start up and shut down machines as required and ensure relevant subsystems are operational.
  • Assist with or perform maintenance on molding machines, robots, hydraulic pumps, gauges, heaters, and other auxiliary equipment.
  • Perform Butyl changes, Nitrogen tank changes, and Urethane changes.
  • Run soft seals for HWN and HWS.
  • Clean tools and replace seals daily.
  • Perform housekeeping and facility upkeep, including cleaning, organizing, and disposing of grease and fluids.
  • Maintain chemical storage areas using 5-S practices.
  • Maintain adhesives storage and FIFO, and monitor day tank and primer levels on all lines.
  • Follow safety and hazardous-waste procedures, including prescribed lockout procedures, and properly handle and dispose of hazardous waste.
  • Inspect parts after changeovers and visually compare parts with process control sheets to verify quality requirements.
  • Communicate equipment performance, changeovers, and schedule changes to appropriate personnel.
  • Perform material-handling duties as requested, including delivering materials and moving or installing molds.
  • Train other staff as needed and perform other duties as necessary.

Benefits

  • Employee support and resources for success.
  • A wide range of development prospects.
© 2026 Teal Labs, Inc
Privacy PolicyTerms of Service