Service & Production Technician

Abstrakt Marketing Group LLC•Santa Rosa, CA

10h•$35 - $40•Onsite

About The Position

The Regional Bay Area Service & Production Technician performs commercial roof repair, maintenance, restoration, and production work throughout the assigned territory. The position supports local rainy-season response while also providing labor capacity for TPO/PVC and acrylic production when repair and maintenance demand is limited. This is a cross-functional field position. The technician must be capable of moving between service work and scheduled production assignments while maintaining safe work practices, quality standards, accurate timekeeping, and job documentation.

Requirements

Commercial roofing experience with demonstrated repair or production capability.
Working knowledge of TPO and PVC systems, including membrane repairs and heat-welded details.
Experience with acrylic coating systems or ability to complete manufacturer and company training.
Ability to understand scopes of work, follow daily production direction, and recognize out-of-scope conditions.
Ability to work safely at heights and in varying outdoor conditions.
Valid California driver’s license and acceptable driving record.
Ability to use mobile devices for timekeeping, photographs, field notes, and job documentation.
Regularly climb ladders and access commercial rooftops.
Lift, carry, and position roofing materials, tools, and equipment up to 75 pounds.
Stand, kneel, bend, crouch, and walk for extended periods.
Work outdoors in heat, cold, wind, and other conditions when work can be performed safely.
Operate standard roofing hand tools, power tools, welding equipment, and coating equipment.

Nice To Haves

OSHA 10 or OSHA 30 training.
Fall-protection training.
First Aid / CPR certification.
Manufacturer training or certifications for TPO, PVC, or coating systems.
Commercial customer-facing experience.

Responsibilities

Perform commercial roof leak repairs and approved corrective work.
Complete preventive maintenance, drain and gutter cleaning, sealant replacement, sealant replacement, penetration repairs, and membrane patching.
Install temporary dry-ins and complete permanent follow-up repairs.
Complete warranty corrections, callbacks, and service punch-list work.
Follow the approved scope and immediately report concealed conditions or work outside the authorized scope.
Protect occupied buildings, customer property, landscaping, and interior operations during service work.
Support tear-off, deck preparation, insulation installation, fasteners, plates, and material staging.
Install mechanically attached and fully adhered TPO/PVC membrane systems.
Perform heat welding, test welds, seam work, temporary tie-ins, and detail installation.
Complete perimeter, curb, drain, scupper, penetration, and flashing details.
Support small reroofs, production punch lists, manufacturer corrections, and project closeout.
Perform roof cleaning, surface preparation, detail repairs, and removal of loose or failed material.
Install reinforcing fabric and three-course details at seams, transitions, penetrations, and repair areas.
Apply acrylic base coat and finish coat at approved coverage rates and within manufacturer weather requirements.
Complete coating touchups, quality checks, cleanup, and material accountability.
Comply with company safety requirements, fall-protection rules, job hazard assessments, and site-specific safety plans.
Inspect ladders, anchors, warning lines, personal protective equipment, power tools, and welding equipment before use.
Record labor hours against the correct job number and work category.
Document work with before, progress, and completion photographs.
Record materials used, completed quantities, unresolved conditions, and return-trip requirements.
Maintain clean work areas, secure loose materials, and provide temporary water protection at the end of each shift.
Communicate job status, safety issues, quality concerns, and scope changes to Operations Management.