Senior Cable and Wire Harness Assembler

DP Gayatri•Plymouth, MN

2d•Onsite

About The Position

Source Engineering & Manufacturing is looking for a Senior Cable and Wire Harness Assembler to join our Plymouth, MN manufacturing site. This is a senior individual-contributor seat where you will take on our most complex builds, run first articles, and set the workmanship standard for newer assemblers. You will build our most complex cable and wire harness assemblies from drawings, schematics, and work instructions with minimal supervision. You will also perform precision wire cutting, stripping, crimping, soldering, potting, labeling, and bundling to IPC/WHMA-A-620 standards. Additionally, you will run and document first-article builds, helping to dial in fixturing and tooling before a job moves to volume. You will read complex engineering drawings and flag errors or ambiguities back to engineering, and inspect your own and others' work for quality and compliance.

Requirements

5+ years of hands-on cable and wire harness assembly experience.
Demonstrated mastery of crimping, soldering, and connector termination across multiple connector families.
Ability to work independently from complex engineering drawings, wire lists, and schematics.
Proven first-time-right workmanship and low defect rates.
Strong attention to detail and disciplined, repeatable technique.
Experience building complete cable assemblies end-to-end, not single-station/high-volume work.
IPC/WHMA-A-620 workmanship standards experience, even without formal certification.

Nice To Haves

Current IPC/WHMA-A-620 certification (CIS); training and certification provided if not already certified.
IPC/WHMA-A-620 CIT (Certified IPC Trainer).
J-STD-001 soldering certification.
Control panel build experience.

Responsibilities

Build our most complex cable and wire harness assemblies from drawings, schematics, and work instructions with minimal supervision.
Perform precision wire cutting, stripping, crimping, soldering, potting, labeling, and bundling to IPC/WHMA-A-620 standards.
Run and document first-article builds, helping dial in fixturing and tooling before a job moves to volume.
Read complex engineering drawings and flag errors or ambiguities back to engineering.
Inspect your own and others' work for quality and compliance.