Screw Machine Operator

PennEngineering®•Winston-Salem, NC

8d•Onsite

About The Position

Operates assigned multiple spindle automatic screw machines to perform a limited range of rough and finish turning, facing, boring, drilling, reaming, tapping threading, forming, and similar machining operations. Performs the job of automatic screw machine operator with assistance, when required, from Team Leader or Troubleshooter. Operates machines at correct feeds and speeds, following standard operating procedures, producing good pieces within acceptable quality control limits per drawings. Receives direction from Team Leader or Troubleshooter and works from detailed machine parts drawings, machine manuals, specifications, tool charts and instructions. As inspection of parts indicate, removes, sharpens, and resets tools, gauges work and makes machine adjustments as necessary. Sets up and assists in setup of the screw machine. Prior to operating screw machines at start of shift, moves parts produced by previous shift, if necessary, away from machines for pickup by the Material Handler or Shipping & Receiving personnel for transportation to be cleaned. Checks to see that there is sufficient bar stock in holder (stock reel) to proceed and that bar stock is correct for the parts ordered. Turns on machine and produces parts. Checks first part from each spindle produced for adherence to quality specifications. If pieces do not pass inspection, shuts off machines, and makes adjustments as needed to produce good parts. Keeps bar stock holder (stock reel) full to prevent any run out of material and loss of productivity.

Requirements

Must be able to stand throughout an entire shift.
Must be able to bend forward, stretching forward, reaching into machines as needed to perform aforementioned job duties.
Visual acuity to read micrometers, inspect small parts, and adjust tooling.
Must be able to lift up to forty (40) lbs, ten (10) times throughout an entire shift.
Occasional lifting up to seventy-five (75) lbs. may be necessary.

Responsibilities

Operates assigned multiple spindle automatic screw machines to perform a limited range of rough and finish turning, facing, boring, drilling, reaming, tapping threading, forming, and similar machining operations.
Operates machines at correct feeds and speeds, following standard operating procedures, producing good pieces within acceptable quality control limits per drawings.
Removes, sharpens, and resets tools, gauges work and makes machine adjustments as necessary.
Sets up and assists in setup of the screw machine.
Moves parts produced by previous shift, if necessary, away from machines for pickup by the Material Handler or Shipping & Receiving personnel for transportation to be cleaned.
Checks to see that there is sufficient bar stock in holder (stock reel) to proceed and that bar stock is correct for the parts ordered.
Turns on machine and produces parts.
Checks first part from each spindle produced for adherence to quality specifications.
Shuts off machines and makes adjustments as needed to produce good parts if pieces do not pass inspection.
Keeps bar stock holder (stock reel) full to prevent any run out of material and loss of productivity.
Inspects and gauges parts as per manufacturing procedures.
Notifies Team Leader or Troubleshooter if parts are falling outside of drawing tolerances, and unable to make necessary adjustments.
Detects and reports faulty operations, defective material and equipment, drawing discrepancies and other unusual conditions to Team Leader or Troubleshooter.
Maintains work place area in a neat and orderly condition on a daily basis, and performs a general machine and work area cleanup daily.
Oils and greases machine, replaces coolant, and replaces drills, taps or inserts as required.
Keeps machine free of chips.
Makes out time, production, and quality reports as necessary.
Collaborates with operators from other shifts to transmit and exchange information pertinent to the work at hand.
Performs other duties as required.