Quality Assurance - Metrology Technician

Viant•Brimfield, MA

4d•Onsite

About The Position

The primary purpose of this job is to provide calibration support for all site inspection equipment to ensure valid calibration status, conforming to internal and external requirements, and in accordance with applicable Regulatory and Standards requirements for compliance. Adheres to Viant Core Beliefs and all safety and quality requirements including, but not limited to: Quality Management Systems (QMS), Environmental Management Systems (EMS), U.S. Food and Drug Administration (FDA) regulations, Company policies and operating procedures, and other regulatory requirements.

Requirements

High School diploma or GED
Technical degree or Associates degree required
0-2+ years experience
Competence in the selection and use of Inspection Tools and Techniques.
Strong communication skills and ability to work in a team environment.
Ability to understand and comply with relevant Domestic and International Regulations and Industry Standards (e.g. FDA 21CRF820, ISO 13485:2016, QSR, etc.)
Must be able to complete prioritized tasks with minimal direct supervision

Nice To Haves

Relative co-op, internship, part-time, or classroom training experience is preferred.
Experience in medical device or regulated manufacturing a plus.
Experience with Microsoft Office, Word, and Excel preferred
Experience with Minitab is a plus

Responsibilities

Maintain Gagetrak system that monitors the calibration cycle and status of all measurement and test equipment.
Maintain any other records, paper or electronic, as required.
Calibrate as required all company (Viant Brimfield) owned equipment as well as customer supplied gaging, either in-house or by an outside vendor, which may include optical comparator, VMM, OGP, CMM, calipers, micrometers, dial/test indicators, gage pins/hard gages, profilometer, surface plates, and height stands.
Repair gages as needed; if unable to do internally, send to an outside repair service and /or request a quote for replacement.
Coordinate sending and receiving gages from customers/vendors.
Coordinate and perform collection of gages due for calibration.
Perform risk evaluations as needed for inspection equipment.
Understanding of GD&T and other blueprint and dimensioning methods.
References with Calibration SME (Subject Matter Expert) when needed.
May assist in executing capability studies and test method validation.
Participate in Continuous Improvement activities as needed.
May assist in performing calibration activities.
Performs other functions as required, such as incoming inspection.