Production Assembly Tech- Hydroplex

A G I Industries Inc•Lafayette, LA

7h•Onsite

About The Position

Responsible for building and testing pumps and other related valves and packages for the Hydroplex Division of AGI Industries, and to perform quality control of machine parts to be used in manufacturing.

Requirements

1 - 3 years-Mechanical background and basic knowledge of hand tools
Working knowledge of industry standard mechanical practices, techniques, tools, and equipment
Working knowledge of occupational hazards and safety precautions of the trade
Ability to understand and carry out oral and written instructions
High School Diploma
Valid Driver’s License
Forklift & Overhead Crane Certification required to begin work

Responsibilities

Obtain production order from Production Foreman
Pick and box parts for production order
Stage pump or valve parts for future assembly if all parts for order are not readily available
Assemble pump or valve upon orders from Production order specifications upon request from Production Foreman.
Maintain production order records throughout the process.
Acquire parts from vendor and check against purchase order for parts identity and quantity
Obtain Hydroplex drawings and match the part numbers to be inspected
Obtain all related measuring tools/parts and match components to perform inspection
Using drawings, measure all critical dimensions on 100% of parts delivered according to Hydroplex standards
Complete Hydroplex Quality Control Report for acceptance or rejection of parts and attach all related Certificates and Material Test reports delivered with parts
Inform Production Foreman that parts are suitable to receive into inventory
Prepare parts as necessary to be labeled, preserved, and inventoried
Carefully put the components in the correct bins
Fill out proper J.S.A. form
Load assembly cart using overhead crane following proper loading procedures
Transfer to test stand using cart or fork lift
Using proper material handling equipment and procedures, mount pump or valve onto test stand
Align pump shaft with motor drive shaft and properly bolt the power frame to deck on test stand
Attach all fluid hoses and prime fluid ends to be free of air before starting
Ensure that applicable safety protocols have been utilized and that all PPE is used before starting the drive motor
Start pump and monitor for at least 1 hour to ensure no unusual noises or leaks are present during operation
After successful run test, remove the pump from the test stand using the same equipment and care used in installation
Cart back to assembly area or shipping areas
Prepare serial number tag for each specific tested pump or valve and install onto designated areas
Load pump and accessories onto pallet for strapping and wrapping
Label shipment with customer, model, and serial number information
Fill out Hydroplex Production Test Report and give to Production Foreman for job closeout
Remove boxes and packing materials from assembly area
Return all tools and measuring equipment to proper storage areas
Maintain lubrication inventory and monitor lubrication condition for acceptable use
Clean assembly table and floor to remove oils and dirt
Maintain clean test stands and label any drums of liquids removed from test areas for proper disposal
Inspect test stand equipment
Inspect safety equipment
Perform additional duties as assigned