Process Engineer - Electrical (TDR, ET, Kelvin)

TTM•Forest Grove, OR

38d•Onsite

About The Position

The Process Engineer is responsible for the implementation and maintenance of processes used to produce printed circuit boards. This includes application engineering of processes developed by suppliers that are planned for use at TTM, installation of these processes and or equipment, establishment of operating conditions to produce TTM product, daily monitoring of process conditions, and performing failure mode effect analysis to determine failure points of the process.

Requirements

Ability to read, write and communicate in English to the degree necessary to perform the job
Knowledge and application of statistical techniques for process control
Knowledge of geometric dimensioning and tolerance
Knowledge and application of failure mode effect analysis techniques as applied to both process development and process improvement
Must be able to lift 25 pounds without straining
Bachelor of Science degree in Mechanical Engineering or related science
0-3 years relevant experience
Must have a general knowledge of methods used to training people in the operation and theory of the processes they operate

Nice To Haves

TDR, ET, Kelvin

Responsibilities

Registration, Mechanical Drill, Laser Drill, or Fabrication
Write all necessary procedures and instructions for process operation, maintenance and safety
Monitor process operation on a daily basis to assure consistency
Perform failure analysis and root cause analysis when product/process problems occur
Maximize process efficiencies, capabilities, and throughput
Drive defect reduction rates
Evaluate and qualify new raw materials, processing tools, and vendors