Press Brake Operator B - 2nd Shift (3:15pm - 11:45pm)

Perlick Corporation•Milwaukee, WI
•Onsite

About The Position

Set up, adjust, and operate press brakes to perform forming and bending operations on materials of various gauges while meeting close dimensional requirements. Position, align, and secure forming dies; adjust ram stroke for the material gauge, angles, and contours; and set stop gauges to match dimensional specifications, templates, or samples. Limited setup knowledge is acceptable when bidding for the position, but at least six months of machine operation experience is required. The operator must be able to perform basic press brake equipment setups within six months and continue learning more advanced setups over time. Established efficiency and productivity standards must be met. Determine bend sequences for multiple-pass work involving bends at varying angles and in different planes. Improvise setups for special shapes, including single or compound radii and angle flanges, carefully adjusting the ram to avoid surface irregularities. Work from drawings, specifications, templates, and samples. Use measuring and inspection tools to set up and check work. Proceed with minimal supervision and take responsibility for the quality of assigned work. Work is subject to process and final inspection. This is a second-shift position, scheduled from 3:15 p.m. to 11:45 p.m., with a $1.00 shift differential. The position is onsite. Sponsorship and relocation are not available. Perlick is an Equal Opportunity Employer and participates in E-Verify.

Requirements

  • At least six months of machine operation experience.
  • Ability to perform basic press brake equipment setups within six months of starting in the position.
  • Knowledge of basic mechanical principles, metal fabricating methods, and basic mathematics, as may be acquired through vocational or high school education.
  • Knowledge of press brake equipment and procedures, typically obtained through two years of high school or vocational school education.
  • Entry-level blueprint-reading skills demonstrated by completion of a basic Welders Blueprint Reading class at a technical school or equivalent.
  • Ability to work from drawings, specifications, templates, and samples.

Responsibilities

  • Set up, adjust, and operate press brakes for forming and bending materials of various gauges to close dimensional requirements.
  • Position, align, and secure forming dies; adjust ram stroke and set stop gauges to match specifications, templates, or samples.
  • Meet established efficiency and productivity standards.
  • Determine bend sequences for multiple-pass operations involving varying angles and planes.
  • Improvise setups for special shapes and carefully adjust the ram to avoid surface irregularities.
  • Work from drawings, specifications, templates, and samples.
  • Use scales, squares, protractors, calipers, micrometers, and angle and radius sweep gauges to set up and check work.
  • Work with minimal supervision and take responsibility for the quality of own work.
  • Meet process and final inspection requirements.
  • Develop basic press brake setup capability within six months and continue learning more advanced setups.

Benefits

  • $1.00 shift differential
© 2026 Teal Labs, Inc
Privacy PolicyTerms of Service