Power and Analog Electronic Engineer Intern (Onsite)

RTX•Tucson, AZ

11d•$37,000 - $82,000•Onsite

About The Position

Raytheon's Effector Analog & Power (EAP) Team is looking for intern level engineers who have power electronics knowledge to help design robust power systems. The EAP Department is responsible for the development, from concept to integration, of Telemetry and Flight Termination products; power systems from all up round to the lowest level power regulation; servo electronics supporting all mechanical motion in our products and low noise mixed signal electronics that provides the analog to digital interface to our front-end sensors. Each of these products generally operate in lower power and voltage ranges less than 10kW and 1000V.

Requirements

Must be pursuing Bachelor’s or Advanced degree in Electrical or related Science, Technology, Engineering or Mathematics (STEM) major and actively enrolled through the completion of the internship/co-op session.
Must have a minimum of 60 hours of credit by the start of the internship / co-op session.
Design, analysis, test, and/or simulation experience with one or more of the following non-isolated converter topologies: buck, boost, buck-boost.
Familiarity using tools such as MATLAB, MathCAD, Mathematica, or other similar tools.
Coursework related to analog electronics design, including at least one of the following: FETs/BJTs, op-amp, high/low/band pass filters, clock/data termination, and comparator circuits.
Active and transferable U.S. government issued security clearance is required prior to start date.
U.S. citizenship is required, as only U.S. citizens are eligible for a security clearance.
Ability to obtain INTERIM U.S. government issued security clearance is required prior to start date.

Nice To Haves

A self-starter, a quick learner, be able to function in a dynamic environment, and have good time management skills.
Familiarity with wide bandgap devices (SiC, GaN) in power electronics designs.
Simulators such as SIMPLIS or SABER, or Mentor Graphics DxDesigner, and/or Hyperlynx.
Design considerations for voltages > 400V and/or power > 10kW.
Three-phase power systems, power factor control, and inverter/rectifier development.

Responsibilities

Design, analyze, simulate, test, and document power conversion (and related analog) circuitry. This circuitry will dominantly involve non-isolated and isolated switch mode power converters and linear converters. Main emphasis is on board-mounted power end use applications.
Help to see circuit card development through its design phases, from requirements definition through initial integration testing.
Guide ECAD drafters through layout and routing activities, with support from senior engineers.
Function as an individual contributor. Understand the role of a small team and engage in personal technical growth.
Clearly present your work product to functional and program leadership.