Pipe & Structural Welder

Western Industrial Resources Corporation•Apache Junction, AZ

24d•Onsite

About The Position

This position involves performing pipe, structural, and general welding using various equipment and techniques. The welder will be responsible for interpreting drawings, preparing materials, operating welding and cutting equipment, and ensuring the quality and safety of their work. This role requires the ability to work in an industrial mining environment, at heights, and as part of a crew, with a strong emphasis on safety protocols.

Requirements

4+ years of welding experience preferred.
Experience with pipe welding, structural welding, fabrication, repair, or industrial maintenance work.
Ability to pass applicable weld tests and site qualification requirements.
Ability to work in an industrial mining environment.
Ability to read and interpret basic drawings, measurements, templates, and specifications.
Experience using common welding, cutting, grinding, fitting, and fabrication tools.
Ability to work at heights, around equipment, and in field conditions.
Strong attention to detail and commitment to quality workmanship.
Ability to work safely as part of a crew and follow supervision.

Nice To Haves

Pipe welding
Structural steel welding
Stainless steel, aluminum, cast iron, or alloy welding
Industrial maintenance welding
Mine site work
Blueprint reading and layout
Fabrication and fit-up
Specialty welding processes or certifications
Welding inspection, supervision, or leadership experience

Responsibilities

Perform pipe, structural, and general welding using hand-welding, flame-cutting, brazing, soldering, and related equipment.
Weld components in flat, vertical, overhead, or combination positions.
Read and interpret drawings, sketches, specifications, work orders, and project requirements.
Examine workpieces for defects and verify fit-up, alignment, gap allowances, angles, and dimensions.
Prepare material surfaces by removing scale, rust, slag, moisture, grease, or other contaminants.
Align, clamp, position, and secure workpieces using hand tools, fixtures, jigs, vises, hoists, cranes, wire, or banding equipment.
Set up and operate welding equipment, cutting torches, grinders, power tools, and other tools common to the welding trade.
Select and install torches, torch tips, filler rods, electrodes, flux, and related consumables based on material type and thickness.
Grind, cut, buff, bend, chip, or clean workpieces to ensure proper fit and weld quality.
Monitor welding, fitting, burning, and heating processes to prevent warping, overheating, shrinking, distortion, or expansion of materials.
Repair fabricated or installed components by cutting, straightening, reshaping, welding, and reassembling parts.
Mark or tag materials with job numbers, piece marks, and other identifying information as required.
Detect defective materials or faulty equipment operation and notify supervision.
Support layout, fit-up, fabrication, and field installation work as assigned.
Use ladders, scaffolding, lifts, or other access methods as required to complete work safely.
Maintain clean, organized, and safe work areas.
Operate safety equipment and follow all site safety requirements.
Use safe work habits at all times.
Follow hot work, fire watch, confined space, and permit-to-work requirements as applicable.
Operate a fire extinguisher or charged water hose when required.
Monitor work areas for sparks, fire hazards, and changing field conditions.
Perform continuous monitoring of work areas with gas detectors or monitors when required.
Record gas readings and document results in permit-to-work paperwork when applicable.
Monitor wind direction, interpret windsocks, and identify changing safety conditions.
Clearly and quickly communicate alarms, warnings, or unsafe conditions to supervision and coworkers.
Use fire suppression methods during industrial emergencies when trained and directed.
Identify when sparks from grinding or welding may create a hazard and communicate concerns to site supervision.