Molder - 2nd Shift

Wabtec•Maxton, NC

3d•Onsite

About The Position

Railroad Friction Products Corporation designs and manufactures Cobra high-friction and low-friction composition brake shoes, specialty shoes, and disc brake linings for freight, locomotive and transit vehicles. As a member of the Railroad Friction Products group/division, you will be responsible for weighing out, assembling, and transporting materials for each molding cycle.

Requirements

High school diploma or general education degree (GED); or one to three months related experience and/or training; or equivalent combination of education and experience.
Ability to read and comprehend simple instructions, short correspondence, and memos.
Ability to write simple correspondence.
Ability to effectively present information in one-on-one and small group situations to customers, clients, and other employees of the organization.
Ability to apply common sense understanding to carry out detailed but uninvolved written or oral instructions.
Ability to deal with problems involving a few concrete variables in standardized situations.

Responsibilities

Follow all company established safety and employment rules.
Identify and use correct materials per the mold charge sheet.
Clean and “soap” molds after each cycle (heat).
Visually check mold pressures and temperatures for maintenance malfunctions.
Move molded shoes from the press to the cleaning table or conveyor.
De-flash excess material from molded slabs and shoes and perform required thickness checks.
Remove bars from slabs properly place slabs into saw.
Visually inspect shoes for defects and notify QA of defects.
Place finished shoes in correct storage boxes.
Report all machine and maintenance problems immediately.
Follow all 5S procedures including standard work.
Record production and quality information.
Regular on-site attendance is required.
Other Duties may be assigned