Millwright Turbine

Fluor•Victoria, TX

4d•Onsite

About The Position

At Fluor, we are proud to design and build projects and careers. We are committed to fostering a welcoming and collaborative work environment that encourages big-picture thinking, brings out the best in our employees, and helps us develop innovative solutions that contribute to building a better world together. If this sounds like a culture you would like to work in, you’re invited to apply for this role.

Requirements

Understand and carry out oral instructions
Read and carry out written instructions to perform work tasks
Work at varying heights
Recognize, avoid, and report safety hazards
Assemble and disassemble objects
Operate equipment and power tools
See hazards, safety warnings, and barriers
Bend knees for lifting and routine work tasks
Stoop for work positioning and lifting to perform work tasks
Lift maximum 50 lbs without assistance
Ability to comprehend, and respond to audible/visual instructions, alarms and warnings
Climb/balance on ladders, scaffolding, and structures for work tasks
Kneel for work positioning and work task performance
Reach above shoulders and away from body to perform work tasks
Demonstrate manual dexterity to perform work tasks

Responsibilities

Follow all health, safely, and environmental requirements
Perform cleanup duties
Perform material handling and storage duties
Identify, use, and care of common hand and power tools
Use and care of craft specific tools and equipment
Knowledge and application of craft related mathematics
Knowledge and use of safety standards and best safety practices relevant to rigging, Inspection of rigging equipment and hardware
Knowledge and application of common hitches, Emergency stop signal, Basic crane hand signals, Knot tying (bowline & clove hitch), and use of rigging equipment relevant to craft specific tasks
Perform oxyfuel cutting operations
Fabricate and install gaskets
Proper selection of fasteners
Fabricate shims
Perform basic lubrication
Remove and install couplings
Establish equipment and machinery
Establish center lines and elevations
Identify various types of bearings
Remove and install bearings
Perform conventional alignment
Perform Layout duties
Perform reverse alignment
Pre-alignment for drilling and tapping
Set baseplates and soleplates
Repair and replace packing
Service mechanical seals
Install and replace bearing and bushing
Review construction drawings and blueprints for specifications to determine work requirements
Install fans and blowers
Install, dismantle, and reinstall Turbine/Generator rotating equipment and associated parts within required precision alignment specifications