Mechanical Shell Remover
About The Position
The Rough Finishing Operative performs one or more rough-finishing operations, including cut-off, blasting, water blasting, alloy type testing, snag grinding, green sorting, and marking. The operator must be capable of performing all operations and operating equipment efficiently. This role is based in Douglas, Georgia, in the Rough Finishing department, at pay level H05. The position involves working in dirty conditions due to ceramic pieces and dust. The operative is responsible for their own work and for ensuring parts meet quality standards. The role requires lifting up to 30 pounds approximately 10–20 times per hour; a chain hoist is used for heavier weights. Daily and weekend overtime may be required as necessary.
Requirements
- High school education.
- Able to lift up to 30 pounds approximately 10–20 times per hour; use a chain hoist for heavier weights.
- Willingness to work daily overtime and weekend overtime as necessary.
Nice To Haves
- Rough Finish experience preferred.
Responsibilities
- Check routings for proper identification and operational routing.
- Operate the pneumatic knockout unit.
- Cut off castings and trim excess gating.
- Hand blast or water blast parts to remove excess ceramic material.
- Check alloy type.
- Perform snag grinding.
- Apply the proper markings to castings using the correct work instructions.
- Visually inspect work for obvious defects.
- Record all work performed by operational codes on a daily basis.
- Keep the work area clean, orderly, and safe, and follow all safety rules.
- Maintain a positive work atmosphere through appropriate behavior and communication with customers, clients, co-workers, and supervisors.
- Perform other duties as required by the Supervisor.
- Ensure parts meet quality standards.
Stand Out From the Crowd
Upload your resume and get instant feedback on how well it matches this job.
What This Job Offers
Job Type
Full-time
Education Level
High school or GED
