Mechanical Assembler - 2nd Shift (Bellows)

Eaton Corporation•East Providence, RI

10d•Onsite

About The Position

The Mechanical Assembler helps to support assembly for our Seals department, and this specific Assembler will support the bellows seals. This is a 2nd shift position with core hours of 3 pm - 11 pm. The hourly rate for this position is $28.83 per hour + $0.60 [er hour shift premium. The Rumford, RI facility is a unionized location. There is a 60 day probationary period, after which you will be considered a union member and begin paying union dues.

Requirements

Minimum of High School Diploma or GED from an accredited institution
Eaton will not consider applicants for employment immigration sponsorship or support for this position. This means that Eaton will not support any CPT, OPT, or STEM OPT plans, F-1 to H-1B, H-1B cap registration, O-1, E-3, TN status, I-485 job portability, etc.
No relocation benefit is offered for this position. Only candidates within a 50-mile radius of the work location will be considered. Active-Duty Military Service member candidates are exempt from the geographical area limitation.
This position requires access to export-controlled information. To conform to U.S. Government export regulations applicable to that information, applicant must be a U.S. person, defined as a (i) U.S. citizen or national, (ii) U.S. lawful, permanent resident (green card holder), (iii) refugee under 8 U.S.C. 1157, or (iv) asylee under 8 U.S.C. 1158.

Nice To Haves

Previous experience working in a production, assembly, or related position in a manufacturing facility.

Responsibilities

Work from prints, method sheets, operation sheets, specification sheets, sketches, and/or verbal instructions to produce parts in accordance with acceptable quality and quantity levels.
Set up and operate small lathes, automatic machines, drill presses, lapping machines, pneumatic drill presses, hydraulic presses and marking. Perform hydraulic tests on parts and assemblies as specified on methods and verbal instructions in K Department.
Perform a variety of secondary machining operations such as turning, boring, chamfering, counterboring, and general assembly work.
Prepare, sandblast components, and run spot welding machine setup by others.
Use micrometers, Vernier’s, vacuum check, monochromatic light, optical flat, stops and guides, plug gages, expansion plugs and indicators. Set speeds and feeds, tools, depth gauges, comparators, and similar instruments.
Machine fixtures, jaws, plugs, and similar parts. Change and reset dull tooling as required. Charge table plates with diamond paste following prescribed methods.
Repair parts and finished seals as instructed or directed by Supervisor
Check own work after first piece check by Supervisor.
Report faulty operation, defective material, and unusual conditions to Supervisor.