About The Position

Under general supervision, the Maintenance Journeyman inspects, tests, adjusts, troubleshoots, calibrates, and repairs process controls when equipment is in or out of service. The role works closely with station operators during repairs and adjustments to control circuits and performs duties of I&C Apprentice and Trainee as well as journeyman-level work. The position maintains and installs electrical, instrumentation, and control equipment and systems, including process control systems, protective circuits, hydraulic and pneumatic systems, emission monitoring equipment, and equipment associated with nuclear radioactive sources. It also includes testing equipment, interpreting results, recommending performance improvements or repairs, maintaining process-control software, and directing and instructing other employees. The employee must follow safe work practices and be able to work at elevations. Candidates must meet the Company’s general qualifications, have the qualifications of an I&C Apprentice, and successfully pass the Plant Operator Selection System/Power Plant Operations and Maintenance (POSS / MASS) program to be considered.

Requirements

  • Meet the Company's general qualifications and possess all qualifications of an I&C Apprentice.
  • Have thorough knowledge of meters, gauges, instruments, and controls; their associated pneumatic, hydraulic, or electrical connections; and tools used for their maintenance, adjustment, and repair.
  • Be able to climb ladders and work at elevations on platforms, scaffolds, grating, and similar structures.
  • Have thorough working knowledge of methods for testing, calibrating, troubleshooting, and repairing instruments, controls, analyzers, mechanisms, and other equipment.
  • Have good knowledge of electronic, pneumatic, and hydraulic circuits and circuit components.
  • Have a good understanding of the principles of coal and fuel-oil combustion and the generation and utilization of steam.
  • Have a good working knowledge of steam turbines, boilers, balance-of-plant equipment, and the functions of equipment located therein.
  • Have thorough knowledge of the operating principles of all water-treating equipment.
  • Be able to understand and use manufacturers’ software to maintain or alter process control systems.
  • Be capable of directing the work of several employees on an assignment.
  • Successfully pass the Plant Operator Selection System/Power Plant Operations and Maintenance (POSS / MASS) program to be considered for the position.

Responsibilities

  • Operate valves to cut trips and place control equipment in or out of service.
  • Blow out lines for primary metering, controls, and trips using air or another fluid medium to keep lines open and operating properly.
  • Troubleshoot, test, calibrate, and repair electrical control circuits, including analog, digital, distributed control, protective trip, and interlock circuits.
  • Run conduit, install clamps and supports, pull conductors, make connections, locate faults in power and control circuits, and make repairs.
  • Test insulation resistance on electrical equipment using a megger and adjust or renew brushes on rotating equipment.
  • Repair and adjust low- and high-pressure hydraulic and pneumatic control systems and components.
  • Install new control equipment.
  • Work with employees from other departments, vendors, and others to troubleshoot, repair, and modify control systems and components.
  • Direct other employees in equipment tests for performance, efficiency, or calibration; analyze test results and recommend equipment performance improvements or repairs.
  • Maintain equipment associated with nuclear radioactive sources, conduct tests, and calibrate equipment as required.
  • Maintain software changes for process control systems.
  • Troubleshoot and repair higher-voltage controls, including exciters, uninterruptible power supplies, and variable speed drives.
  • Verify field-marked process control system drawings before submitting them for changes.
  • Troubleshoot, repair, and calibrate stack gas emission monitoring equipment, including opacity monitors and continuous emission monitors.
  • Maintain safe work practices using safety-related equipment, materials, and training.
  • Instruct and train employees in any classification in their work.
  • Install meters, relays, recorders, switches, and similar equipment on switchboards and make required wiring connections.
  • Tape high-voltage connections above 6900 volts.
  • Perform similar or less-skilled work and duties of I&C Apprentice and Trainee.
© 2026 Teal Labs, Inc
Privacy PolicyTerms of Service