Machinist Supervisor I

United States Fleet Forces Command•Kittery, ME

1d•Onsite

About The Position

You will serve as a Machinist Supervisor I in the Mechanical Shop, Production Resources Department of Portsmouth Naval Shipyard. You will supervise the assembly of finished parts and the repair and refitting of shipboard components. You will consult with engineers, shop planners, schedulers, planners, and estimators about technical problems to avoid delays and meet schedules. You will ensure assigned work is accomplished efficiently and economically through subordinates, within general work schedules established by higher-level supervisors. The role also includes supporting the Equal Employment Opportunity (EEO) Program and directing work operations, supporting on-the-job training, addressing unsafe conditions, and making recommendations concerning subordinate employees. The position requires wearing personal protective equipment throughout the work shift and working in areas where potentially harmful physical and chemical agents may be present. It may involve travel to locations in the continental United States and overseas, including remote or isolated sites, and extended travel on military or commercial aircraft. Work may include an uncommon tour with nights, weekends, and holidays; overtime, night differential pay, or unusual duty hours may be required.

Requirements

Must be a U.S. citizen.
Must be determined suitable for federal employment.
Must participate in the direct deposit pay program.
Must successfully pass the E-Verify employment verification check if new to the Department of the Navy.
Must successfully complete a pre-appointment physical examination.
Must obtain and maintain an interim and/or final security clearance before entering on duty.
Must wear required personal protective equipment continuously for the duration of the work shift.
Must participate in medical surveillance programs.
Must be able to travel from the normal duty station to locations in the continental United States and overseas, potentially including remote or isolated sites, and travel on military or commercial aircraft for extended periods.
Must demonstrate knowledge and skill sufficient to perform the duties at the level applied for; applicants must meet the applicable OPM qualification requirements for Trades and Labor Occupations.
Must receive at least two points on the Ability To Lead Or Supervise screen-out element to be eligible.
Must be able to direct assigned work operations, review and assist with subordinate training, correct unsafe working conditions, initiate recommendations for subordinate promotions or reassignments, and consult with design representatives on technical details.
Males born after December 31, 1959, must be registered for Selective Service.
Must review the 14 General Principles of Ethical Conduct at 5 CFR 2635.101.

Responsibilities

Fully support the Equal Employment Opportunity (EEO) Program.
Supervise assembly of finished parts and repair and refitting of shipboard components.
Consult with engineers, shop planners, schedulers, planners, and estimators on technical problems to avoid delays and meet schedules.
Ensure efficient and economical accomplishment of work assignments through subordinates within schedules set by higher-level supervision.
Direct assigned work operations within management policies, production schedules, and oral and written instructions.
Review and assist with on-the-job training for subordinates and supplement training programs as needed.
Take corrective action on unsafe working conditions in the supervised area.
Initiate recommendations for promotions or reassignments of subordinates.
Consult with design representatives regarding technical details.

Benefits

Federal employees and their families have access to a comprehensive benefits package; specific benefits depend on position type and should be confirmed with the hiring agency.

Stand Out From the Crowd

Upload your resume and get instant feedback on how well it matches this job.

Upload and Match Resume