Machinist - Manual

Ohmstede Ltd.•Beaumont, TX

2d•Onsite

About The Position

Ohmstede Ltd is looking for an individual that under the direction of the Machine Shop Foreman is assigned to drilling flanges, tubesheets and baffles used in fabrication and/or repair of shell and tube heat exchangers.

Requirements

H.S. diploma or equivalent; or equivalent experience.
Able to work a 12 hour shift when necessary.
Must pass drug screen.
Read and write English language.
Able to read and interpret blueprints, scales, micrometers, and depth mics.
Familiar with fabrication and machining prints and tolerances.
Familiar with flatness tolerances.
Able to convert and understand fractions and decimals.

Nice To Haves

At least 2 years of experience operating Vertical Boring Mills/Vertical Turret Lathes.
Machining stainless steels, alloys, and carbon steel.
Worked in a custom fabrication shop.
Operating jib and bridge cranes.
Machining raised face tube sheets a major plus.
Machining weld necks and flanges a major plus.

Responsibilities

Set raw material in the machine.
Adjust tools.
Operate the following machines - Horizontal boring mill, Vertical boring mill, Lathes, Drill presses and Bridgeport knee mills.
Check / refill lubricating fluids periodically.
Perform preventative maintenance on the mill.
Inspect finished product.
Report and correct defects as required.
Perform assigned tasks in a safe manner, avoiding and reporting unsafe practices.
Perform internal quality control of machining procedures.
Setup and perform work based on shop practices and procedures.
Removes shavings as needed.
Must be able to work 1st (0330-1530) or 2nd (1530-0330). Shifts vary between 8-12 hours depending on work load, and are subject to change.
Other duties as assigned.