Journeyman Carpenter - AIT

Ahtna•Anchorage, AK

1d•Onsite

About The Position

This position will be based out of and will primarily be based in Anchorage, AK; requires travel to remote areas in the state and will report to the corresponding Project Superintendent or designee. Perform tasks involving physical labor indoors and outdoors, including movement of material, equipment, and parts between production areas, operating hand/power tools of all types, including air hammers, surveying, and measuring equipment, and a variety of other equipment and instruments. May clean and prepare sites, dig trenches, set braces to support the sides of excavations, erect scaffolding, clean-up rubble and debris. May assist other craft workers. This position requires up to 75% travel; hours worked while in travel status could be up to 12 hours per day. The pay rate for this position is $40.00/hour Admin Rate. Please note this is a Seasonal position.

Requirements

High School Graduate or General Education Degree (GED)
Five (5) years of experience as Journeyman Carpenter
Knowledge of construction machines and tools; includes their designs, uses, repair and maintenance, and the practical application of use
Valid Driver’s license with ability to be covered under company vehicle policy, and the ability to travel to local facilities
Ability to pass background checks by various Federal Agencies (e.g., DOD, DHS, FAA, etc.) to obtain security access badges
Some positions may require U.S. Citizenship
Ability to read all disciplines of drawings, perform layout, and subcontractor coordination

Nice To Haves

Technical school in the art of carpentry
OSHA 10 Training Certificate
Knowledge and experience with Alaska Native cultures
Shareholder Preference: Pursuant to PL 93-638, as amended, preference will be given to qualified Ahtna Native Corporation Shareholders, Descendants, and Spouses in all phases of employment.

Responsibilities

General manual labor
Finish carpentry work at a journeyman level
Signal equipment operators to facilitate alignment, movement, and adjustment of machinery, equipment, and materials.
Spray materials such as water, sand, steam, vinyl, paint, or stucco through hoses to clean, coat, or seal surfaces.
Tend machines that pump concrete, grout, cement, sand, plaster, or stucco through spray guns for application to ceilings and walls.
Tend pumps, compressors, and generators to provide power for tools, machinery, and equipment, or to heat and move materials such as asphalt.
Lubricate, clean, and repair machinery, equipment, and tools.
Build and position forms for pouring concrete and dismantle forms after use using saws, hammers, nails, or bolts.
Clean and prepare construction sites to eliminate possible hazards.
Control traffic passing near, in, and around work zones.
Dig ditches/trenches, backfill excavations, and compact/level earth to grade specifications using picks, shovels, pneumatic tampers, and rakes.
Erect and disassemble scaffolding, shoring, braces, traffic barricades, ramps, and other temporary structures.
Load, unload, and identify building materials, machinery, and tools, and distribute them to the appropriate locations according to project plans/specifications.
Measure, mark, and record openings and distances where construction work will be performed.
Raze buildings and salvage useful materials.
Demo various Architectural finishes, such as, but not limited to, carpeting, ceiling tile, drywall, etc.
Patch, repair and install various Architectural finishes, such as, but not limited to, carpeting, ceiling tile, drywall, etc.
May supervise, or escort other workers or subcontractors and ensure that safe work practices are employed at all times.
Read and interpret plans, instructions, and specifications to determine work activities.
Perform any other duties as assigned by management.