Inspector C - 2nd Shift (Quality)

Eaton Corporation • Waukesha, WI

1d • Onsite

About The Position

Eaton’s ES AMER ESS division is currently seeking an Inspector C - 2nd Shift (Quality) to join our team on Badger Dr. in Waukesha, WI! The hourly rate for this position is $24.45 per hour + $2.50 per hour shift premium. The core hours are 3 pm - 11 pm. Overtime may exceed these hours and be mandatory at times. This position is offering a sign-on bonus of $2,000, paid in two installments, less applicable withholding. Bonuses are being offered for a limited time only. Applications must be submitted on or after January 1st, 2026 to qualify. Bonuses are only applicable to specific job types and shifts; additional terms and conditions may apply. Associates must be employed at the time of the payout.

Requirements

• High school graduate or GED equivalent from an accredited institution.
• Minimum of 1 year of manufacturing experience
• Ability to work overtime when required.
• Ability to lift up to 50 LBS; bend, twist, grab, reach, stand, walk, push, pull, use both hands to lift and lower materials, and perform all other essential duties with or without reasonable accommodations.

Nice To Haves

• Education in AC/DC fundamentals or completion of electricity coursework from an accredited institution or a minimum 1 year of experience in electricity

Responsibilities

• Performs assembly inspection of transformers/regulators at various locations in the assembly plants per established procedures.
• Perform electrical testing on assembled single and three-phase transformers/regulators per established procedures and monitor conformance to quality standards.
• Perform routine factory dielectric tests per established procedures, including OX (induced), QC impulse, and hipot (applied potential).
• Perform routine factory loss tests per established procedures, including load loss (winding loss) & no-load loss (core loss).
• Perform power factor, ratio, and resistance tests per established procedures.
• Perform operational tests on regulators as required.
• Perform continuity test on unit per established procedures.
• Follow routine tests inspect unit nameplate, stamp impedance value on nameplate, and secure nameplate to tested unit.
• Perform visual inspection on interior of unit upon completion of testing.
• Perform minor maintenance of test equipment.
• Perform special routine tests when required.
• Perform visual inspection of units throughout the assembly process per established procedures.
• Perform the following tests as required per established procedures: ratio, resistance, leak, continuity, control box, insulation resistance, regulator sub-assembly, regulator modification, regulator run-in.
• Apply decals and stencils to exterior of unit and perform paint mileage check as required.
• Assist Engineering and Manufacturing in identifying and resolving shop floor problems.
• Complete various company forms to communicate inspection status and other information and to document inspection results per established procedures.
• Collect various types of data per established procedures as required.

Benefits

• Health benefits
• vacation time
• Paid holidays - up to 12!
• Weekly pay
• Shift premiums - $2.50/hr for off shifts
• Opportunities for overtime.
• Career progression opportunities to cross-train in different departments and increase compensation.
• Retirement benefits
• Paid Parental Leave
• Educational Assistance Program
• Wellness Reimbursement

What This Job Offers

• Job Type: Full-time
• Career Level: Mid Level
• Education Level: High school or GED