2nd Shift Holesaw Weld Operator – $21.75/hour

Stanley Black & Decker•East Longmeadow, MA

1h•Onsite

About The Position

As a Holesaw Weld Operator, you will be part of our Stanley Black & Decker team. You will perform duties involved in setting up and operating automatic blanking, heat treat forming, and robotic tig welding of various size holesaws. This is a demanding, fast-paced position resulting from deadline pressures, simultaneous competing demands, and changing priorities.

Requirements

High school diploma or GED
1 to 2 years of relevant experience preferred
Knowledge of charts, specifications, and micrometers
Ability to use numbers including decimals
Mechanical ability/aptitude
Light physical effort required, equivalent to lifting, pushing, pulling 5 to 25 pounds

Responsibilities

Work from priorities provided, travelers, written or verbal instructions.
Setup, change over and operate nitrogen forming furnace per established procedure.
Setup robotic and semi auto tig welders of various size.
Load shell & cups onto robotic pallet or manually load into tig welder chuck.
Start automatic cycle to weld.
Visually inspect each saw for quality of weld.
Adjust speed, length and position of stroke, seam current and cup current for proper heat.
Position welding head and change tungsten tips as required using setting gauge according to established procedure.
Rework or scrap any saw found to be out of spec.
Check the quality of each holesaw for total roundness, weld height, weld penetration.
Degrease cup when necessary, working from travelers and record data according to established procedure.
Maintain equipment and work area in a neat and clean condition.
Report any discrepancies, equipment malfunctions, defective material or other unusual situations to the Foreman.
Observe and obey all safety rules, regulations and practices and employ all safety equipment and devices.
Perform other similar or related duties as assigned or directed.