Fixer

Phifer Incorporated • Tuscaloosa, AL

16d • Onsite

About The Position

The Fixer position in the Metals Product Line is responsible for maintaining and repairing mechanical equipment used to support a battery of looms designed to weave wire into mesh. Management may assign additional duties as needed.

Requirements

• Performing established procedures

Responsibilities

• Set-up, adjust and make repairs to looms that weave metal screening to specified quality and design by performing established procedures.
• Inspect loom and woven material to determine adjustments or repairs needed as documented by performing established procedures.
• Use diagrams and manuals to maintain equipment properly by performing established procedures.
• Repair or replace defective parts and adjust tension and timing of parts using hand tools by performing established procedures.
• Level and align parts to prevent excessive wear by performing established procedures.
• Check Fixer log when working on looms to see what has been done before attempting to fix looms so there will not be any repeated problems with loom by performing established procedures.
• Stop any loom that has defects, finding the cause of defect and fixing loom so defect does not occur again by performing established procedures.
• Work with the #1 Fixers, Mechanics, and #2 Fixers when available on issues and be able to look up parts in parts manuals and on the computer by performing established procedures.
• Perform end of shift duties by performing established procedures.

What This Job Offers

• Education Level: No Education Listed