Fitter/Welder

DBM GLOBAL INC•Stockton, CA

1d•$25 - $31•Onsite

About The Position

The Fitter/Welder assembles, fits, and welds structural, plate, and mechanical materials for steel and bridge fabrication projects. The role requires proficiency in welding in all positions, interpreting drawings and blueprints, and understanding how heat affects structural metals. The position involves fitting materials to drawing dimensions, preparing and finishing welds, and ensuring completed work conforms to drawings and notes. Candidates must pass the required welding and fitter tests, including the AWS D1.1 weld test. The position is based at the Stockton shop in Stockton, California, is full-time, and has no travel requirement. The listed hourly salary range is $25.00–$31.00. The company offers competitive market-based compensation, comprehensive health insurance benefits, and professional development opportunities.

Requirements

High school diploma or GED, and/or 12 months of stable work experience.
Pass the required weld test and fitter test.
Pass the AWS D1.1 welding test and hold the stated AWS D1.1 weld-test certification.
Knowledge of blueprints and common heat reactions of structural metals.
Ability to use a variety of hand tools and welding equipment.
Ability to read and interpret safety rules, operating and maintenance instructions, procedure manuals, and blueprints.
Ability to perform basic arithmetic using all units of measure.
Ability to understand and carry out written, oral, or diagrammed instructions and address problems involving several concrete variables in standardized situations.

Responsibilities

Follow applicable welding procedures, including AWS and AISC requirements.
Weld at ground level, above ground, and below ground in any required position.
Chip, peen, and grind material to prepare it for welding or finish it afterward.
Weld structural materials such as plates, sheets, girders, and tanks, sometimes involving uncommon structural or machine metals and close tolerances for heat application and workmanship.
Straighten materials using heat or flame.
Perform gouging and scarfing as needed.
Receive and interpret instructions, prints, sketches, and work orders; read blueprints and plan fitting operations.
Direct and assist with handling and spreading materials and assemble them according to detail drawings.
Handle and place detail material in assemblies; position bolts, drift pins, and other fastening devices in the proper locations.
Lay out work lines or fit up jigs for positioning materials when required; check, square, and scribe detail connections.
Ensure work conforms to drawings and accompanying notes.
Clean material by grinding or chipping.
Burn and tack weld for assembly purposes; burn, cope, bevel, and straighten material.
Perform minor layout and spot paint identification marks.
Move material to and from the work area and move welding equipment to material when necessary.
Position component parts on a table held by a fixture or jib and tack them when required.
Maintain a clean and organized work area.
Perform other routine duties as directed by management.
Follow all safety rules and personal protective equipment requirements.