Finishing Operator 1st Shift

PCC Talent Acquisition Portal•Wickliffe, OH

2d•Onsite

About The Position

This position is responsible for identifying manufacturing defects on cores and repairing them by patching or trimming. The operator will use an air gun with a diamond tool to trim flash, die lines, and cut tie bars on all cores. Key responsibilities include handling cores with care, following Standard Operating Procedures, producing parts within set standards, identifying core defects, and maintaining accurate records. A 100% visual inspection is required before working on cores. The role also involves identifying and patching negatives on low-pressure cores, removing die lines, poking holes, making dimensional checks, applying tac wax, microblasting glass rods, and correctly disposing of blue dye cores. Additionally, the operator must identify cracks and voids, trim flash, die lines, and remove tie bars on low-pressure cores, run the dip process when needed, maintain accurate documentation, and adhere to all safety procedures and housekeeping standards. Other duties may be assigned by supervision.

Requirements

Must be able to perform in a self-directed environment with little supervision
Ability to follow instructions
Ability to interpret quality specifications and procedures
Ability to analyze problems
Ability and willingness to work overtime if needed to meet schedules
Must be willing to assist peers to accomplish tasks
Basic geometry skills required
Operator needs to be able to comprehend and read procedures

Responsibilities

Identify manufacturing defects on cores
Patch or trim cores to repair defects
Use air gun with diamond tool to trim flash, trim die line and cut tie bars on all cores
Handle a variety of cores with care
Follow Standard Operating Procedure for Finishing
Stamp Identification on cores
Produce quantities within set standards of each part number
Identify core defects
Maintain accurate records (routers, CQCS, etc.)
Perform 100% visual inspection before working on cores
Identify negatives on all low-pressure cores and patch according to procedure
Remove die lines and excess Ludox Poke Holes per QEI
Make dimensional checks of holes and slots
Apply tac wax
Microblast glass rods
Correctly complete and disposition blue dye cores
Identify cracks and voids on all cores and patch according to procedure
Use air gun with diamond tool and/or hand tools to trim flash, trim die line and cut and remove tie bars on all low-pressure cores
Run dip process when needed
Maintain accurate records/documentation and eventually enter information into computer
Follow and adhere to all safety procedures
Maintain department standards for housekeeping/6S
Other duties as assigned by supervision