Finishing Operator Assistant| Monday - Friday

Shaw Industries•Dalton, GA

7d•Onsite

About The Position

This position is Monday- Friday 3pm-11pm. The objective is to maintain correct and steady application of latex onto carpet, provide assistance to coater operator and froth operator.

Requirements

Maintain correct and steady application of latex onto carpet.
Provide assistance to coater operator and froth operator.
Fix and report folded carpet.
Identify style to be run using Sew-In Tracker screen.
Reference spec sheet to identify correct application settings.
Enter correct settings into Latex Control System.
Manually check gap with gages and adjust system if necessary.
Visually inspect latex application and troubleshoot using Latex Control System.
Make sure end dams are set up correctly and latex is not getting on carpet selvage.
Manually check cupweight and viscosity 4 times per shift and log in notebook.
Ensure proper operation of pre-coat pumps and blenders.
Ensure soap, water, latex tank levels are sufficiently high.
Clean out precoat filter baskets twice per week.
Relieve the coater operator for breaks and absenteeism.
Relieve the froth operator for breaks and slack time.
Conduct secondary application weight checks.
Place 3 two-part paper forms on secondary (after application) as secondary rises to the marriage roller.

Responsibilities

Ensure carpet is feeding correctly into precoat direct applicator and Tillotson adhesive applicator, fixing and reporting folded carpet to Coater Operator and Sew-on Operator.
Identify style to be run using Sew-In Tracker screen.
Reference spec sheet to identify correct application settings for the given style, including application (precoat and adhesive), cupweight, puddle height (precoat and adhesive), and gap.
Enter correct settings into Latex Control System.
Manually check gap with gages and adjust system if necessary.
Visually inspect latex application and troubleshoot using Latex Control System, notifying supervisors of issues.
Ensure end dams are set up correctly and latex is not getting on carpet selvage, adjusting end dams as necessary.
Perform all previous steps again for each style change.
Manually check cupweight and viscosity 4 times per shift and log in notebook, also doing this for any backing or weight check requested by supervisor.
Ensure proper operation of pre-coat pumps and blenders.
Make sure soap, water, and latex tank levels are sufficiently high.
Clean out precoat filter baskets twice per week.
Report any issues to supervisor.
Relieve the coater operator for breaks and absenteeism, being held responsible for all duties of the coater operator during this time.
Relieve the froth operator for breaks and slack time (when froth operator is changing out secondary backing), being held responsible for all duties of the froth operator during this time.
Conduct secondary application weight checks at the direction of a supervisor by placing 3 two-part paper forms on secondary (after application) as secondary rises to the marriage roller (alley side, center, and wall side).