Field Service Tech III

Forum Energy Technologies•Clearfield, PA

3d•Onsite

About The Position

Installs, calibrates, services, repairs production equipment both at the manufacturing plant and pad location. Applies knowledge and experience to troubleshooting situations and commissioning functions. Liaises back to the office reporting activities completed and issues.

Requirements

High mechanical aptitude.
Good understanding of P and ID’s/ISO’s to be able to review piping and vessel layout to allow troubleshooting and safe working.
Basic knowledge of instrumentation, electronics and controls.
Basic knowledge of hydraulics and pneumatics.
Knowledge of Burner Management Systems.
Knowledge/experience of the Oil and Gas industry.
Knowledge of PLC’s and the associated logic.
Knowledge of Production and Midstream equipment.
Strong enough electrical knowledge to assist with detail design of control systems.
High School Diploma required.
5-7 years of experience.

Nice To Haves

Technical training or the equivalent preferred.

Responsibilities

Must understand and comply with all company safety rules and regulations.
Perform work in a professional and safe manner, report unsafe work practices
Must be willing to travel; approximately 30%-100% of the workweek, including overnight stays as required. This will vary greatly depending on the work cycle.
Electrical control understanding with the ability to troubleshoot PLC’s and other electrical systems on production equipment is preferred.
Experience commissioning or startup of Oil and Gas Production and Midstream equipment.
Able to identify, evaluate, install and repair related Oil and Gas production and Midstream equipment.
Experience in Dehydration equipment cleanings and trouble shooting
Ability to repair equipment, read schematics, wiring diagrams, P and I D’s.
Provide input for designs from an operational viewpoint at varies stages of the project.
Able to complete all documentation as required i.e. reports for activities completed/reports for issues found.
Work with minimal supervision with remote support.
Self-starter, willing to establish new connections in the industry to offer support and grow the on-site service work.
Capable of performing on the job training of equipment.
Work assignments carried out to highest quality level.
Perform various other duties assigned by supervisor within the physical constraints of the job.
Knowledge of pneumatic and electronic controls.
Other duties as assigned.