Electronic Tester - 1st Shift

Eaton Corporation•Glenolden, PA

2d•Onsite

About The Position

The Electronic Tester is responsible for testing electro-mechanical products for compliance to Acceptance Test Procedures (ATPs) and customer/internal drawings. Work with PMO, as needed, for customer witness test. You will work with critical aircraft components (chip detectors) that directly support reliability and safety in flight.

Requirements

High School Diploma or GED equivalent from accredited institution
Minimum of 2 years of experience in electro-mechanical environment
Must be a U.S. person within the meaning of ITAR (U.S. Citizen, U.S. Permanent Resident, Political Asylee, or Refugee).

Nice To Haves

Associates or Technical degree in Electronics or related field from an accredited institution.
Minimum of 2 years of electronic testing experience in a manufacturing environment.
Basic understanding of pressure theory, electronic theory, and, Ohm’s law and the relationship between resistance, current, and voltage.
When an assembly fails resistance at in process or final test the employee should be capable of diagnosing and recommending fixing, where applicable, in most cases.
Capable of measuring resistor components with multimeter
Ability to perform ATP product testing using Labview programming interface and test racks.
Knowledge of High and Low pressure test vessels and safety precautions when working
Proper use of Mil-Spec oils and gasses
Basic Electronics and Mechanical Theory in relation to PC Board troubleshooting

Responsibilities

Verify product compliance to Acceptance Test Procedures (ATP) / drawings and maintain accurate ATP records.
Utilize test fixtures and test equipment including oscilloscopes, function generator, device programmer, mass spectrometer, vibration table, tenney chamber, hot oil room, etc. to perform ATP.
Troubleshoot and diagnose common failure modes when test failures occur.
Inspect and diagnose PC Boards to component level (for failure analysis).
Work from work orders, engineering drawings, and visual/written work instructions to assemble electro-mechanical components.
Coordinate with Engineering group for shared resources and test validation.
Identify and initiate continuous improvement for product safety, quality, and efficiency.