Electrician Maintenance Project Crew - All Shifts - RVI Scranton

Tyson•Scranton, AR

10d•Onsite

About The Position

This role is for an Electrician Maintenance Project Crew member responsible for maintaining electrical systems in a plant environment. The position requires a comprehensive understanding of various electrical systems, including AC motor and DC drive systems, and the ability to work with schematics. The role also involves troubleshooting, maintenance, and installation of electrical components, as well as assisting with various project-related tasks that may include welding, hydraulics, power transmissions, pneumatics, fabrication, pipe fitting, rigging, mechanical layout, and plumbing. The job also entails operating heavy industrial equipment and performing other duties as delegated by management to ensure the welfare and operational efficiency of the plant. A strong knowledge of safety codes and procedures is essential.

Requirements

Electrician Maintenance EC01 – EC08.
1 plus year of accumulative electrical or industrial maintenance or millwright experience required.
Good working knowledge of all OSHA, NEC Codes and Plant Safety Policies and Procedures.
Able and willing to work weekends, and any/all other hours as needed to complete the project.
Able to travel, which will be required to complete jobs at other facilities.
Able to work more than 12 hours if needed.
Must be willing and able to perform the physical requirements of the job with or without a reasonable accommodation.

Nice To Haves

Welding
Hydraulics
Power Transmissions
Pneumatics
Fabrication
Pipe Fitting
Rigging
Mechanical Layout
Plumbing
Rigging experience/certifications.

Responsibilities

Understand and work with 110, 240, 480-volt AC motor and DC drive systems.
Read and work off schematics.
Use all electrical hand tools.
Estimate and design basic electrical systems.
Troubleshoot and maintain electrical systems in the plant.
Perform any/all other duties to maintain the welfare of the plant.
Install/replace conduit.
Assist in projects requiring skills in welding, hydraulics, power transmissions, pneumatics, fabrication, pipe fitting, rigging, mechanical layout, and plumbing.
Perform other duties as delegated by management such as welding, cutting, equipment removal and installation, structural fabrication, pipe fitting, and heavy equipment set up.
Use various electrical and pneumatic power tools and equipment, including cranes and lifts.
Perform removal, installation, and setup of rendering equipment, including conveyors, pumps, cookers, hydrolyzers, presses, power transmission components, steam traps, ramps, catwalks, and piping.
Perform all other duties assigned by Supervision.
Figure and calculate wire and pipe sizes.
Line up pipe runs.
Calculate estimated completion times.
Weld and use cutting tools such as cutting torch, plasma cutter, grinders, etc.
Perform basic electrical work and use basic electrical tools including a digital multi-meter, wire/unwire 3 phase motors, and basic single-phase terminations.
Operate heavy industrial equipment such as crane, boom lift, scissor lift, telehandler, forklift, etc.
Perform fabrication to build catwalks, handrails, transitions, equipment supports, etc.
Perform rigging.
Climb stairs and ladders.
Lift more than 60 lbs.
Read and understand policies, procedures, and regulations.
Document information.
Communicate with others written and verbally.