Electrician Craftsman 2

Kiewit•Abilene, TX

About The Position

The Electrician Craftsman 2 plans, lays out, installs, tests, and repairs wiring, electrical fixtures, apparatus, motors, equipment, and control systems in accordance with applicable plans, specifications, codes, and industry standards. This intermediate-level role involves interpreting drawings and plans, selecting procedures and tools, installing electrical infrastructure and equipment, testing systems for compatibility and safety, and troubleshooting or repairing defective systems. Work is performed in a construction or industrial environment, including work with high- and low-voltage systems.

Requirements

Experience as an electrician in a power plant or industrial setting.
Working knowledge, skills, and abilities for the position.
Ability to understand, follow, and communicate written and oral instructions effectively with management and supervision.
Ability to use hand tools, power tools, and layout tools safely and efficiently.
Ability to move about a construction or industrial site and to stand, walk, sit, reach, stoop, kneel, crouch, and/or crawl.
Ability to work in changing outdoor weather conditions and in noisy, dusty, confined, cluttered, and uneven environments.
Ability to work irregular hours, weekends, overtime, and holidays as required.
Ability to use ladders, mechanical platforms, manlifts, or scaffolds to access work areas, potentially above 200 feet, and to climb and maintain balance on formwork, steel formwork, stairs, ladders, and scaffolds.
Ability to move items weighing up to 50 pounds across a construction or industrial site.
Must have the required tools.
Ability to pass pre-access drug and alcohol testing and a fit-for-duty medical evaluation.

Responsibilities

Interpret drawings, sketches, software, and plans, and determine appropriate work procedures, tools, and equipment to troubleshoot and repair problems.
Measure, cut, bend, thread, assemble, and install electrical conduit; weld supports; install cable and duct banks; and make terminations.
Install control and distribution apparatus and fasten them in place.
Test and start up systems and check circuit continuity to ensure electrical compatibility and component safety.
Observe installed equipment and systems to identify hazards or determine whether adjustments, relocation, or replacement are needed.
Pull wire through conduit and connect wiring to lighting fixtures and power equipment as required.
Work with high- and low-voltage systems.
Disassemble and repair defective electrical equipment or systems.
Operate electrical and mechanical hand tools, power tools, and hydraulic, pneumatic, and electrical tools.
Observe and comply with safety and project rules and perform other duties as required.