Electrician Craftsman 1

Kiewit•Abilene, TX

About The Position

Plan, lay out, install, test, and repair wiring, electrical fixtures, apparatus, motors, equipment, and control systems in accordance with applicable plans, specifications, codes, and industry standards. This is an intermediate-level position involving electrical work in a power plant or industrial setting. The role requires interpreting drawings and plans, selecting procedures and tools to troubleshoot and repair problems, installing conduit and electrical equipment, testing and starting up systems, and repairing defective equipment. Work takes place at a construction/industrial site, with exposure to outdoor weather, noise, dust, confined or cluttered areas, and uneven surfaces. The employee may need to access equipment using ladders, platforms, manlifts, or scaffolding, and must be able to move items weighing up to 50 pounds.

Requirements

  • Experience as an electrician in a power plant or industrial setting.
  • Working knowledge, skills, and abilities relevant to the position.
  • Ability to understand, follow, and communicate written and oral instructions effectively with management and supervision.
  • Ability to use hand tools, power tools, and layout tools safely and efficiently.
  • Must have required tools.
  • Ability to pass pre-access drug and alcohol testing and a fit-for-duty medical assessment.
  • Ability to move about a construction/industrial site and stand, walk, sit, reach, stoop, kneel, crouch, and/or crawl.
  • Ability to climb and maintain balance on formwork, steel formwork, stairs, ladders, and scaffolds; access equipment/work areas at heights that may exceed 200 feet.
  • Ability to work in confined and cluttered places and on uneven surfaces, and complete tasks in noisy and dusty environments.
  • Ability to move items weighing up to 50 pounds across a construction/industrial site.
  • Work irregular hours, weekends, overtime, and holidays as required.

Responsibilities

  • Interpret drawings, sketches, software, and plans, and determine appropriate work procedures and tools to troubleshoot and repair problems.
  • Measure, cut, bend, thread, assemble, and install electrical conduit; weld supports; install cable and duct banks; and make terminations.
  • Install control and distribution apparatus and fasten it in place.
  • Test and start up systems and check circuit continuity to ensure electrical compatibility and component safety.
  • Observe installed equipment and systems to identify hazards and determine whether adjustments, relocation, or replacement are needed.
  • Pull wire through conduit and connect wiring to lighting fixtures and power equipment as required.
  • Work with high- and low-voltage systems.
  • Disassemble and repair defective electrical equipment or systems.
  • Operate electrical and mechanical hand tools and power, hydraulic, pneumatic, and electrical tools.
  • Observe and comply with safety and project rules, and perform other duties as required.
© 2026 Teal Labs, Inc
Privacy PolicyTerms of Service