Electrical Engineer

Subsense•Mountain View, CA

32d•Hybrid

About The Position

Design and develop electronics and integrated hardware for emerging neurotechnology and medical-device systems. Initial work may include focused ultrasound platforms, while the role is expected to support and adapt to other stimulation, sensing, and experimental hardware approaches as technical needs evolve. You will take hardware from early concepts and laboratory prototypes through characterization, verification, and preparation for manufacturing. Working closely with specialists in neuroscience, mechanical engineering, and software, you will translate experimental requirements into reliable, measurable system performance. This role suits a hands-on engineer who enjoys building and troubleshooting hardware, working across disciplines, and making sound engineering decisions as requirements evolve.

Requirements

Master’s degree in electrical engineering, biomedical engineering with a strong electronics focus, or equivalent practical experience.
Hands-on experience developing electronics for medical devices, neurotechnology, instrumentation, or related experimental hardware systems; experience with ultrasound systems is a plus.
Strong grounding in analog and mixed-signal design, power electronics, signal integrity, grounding, and noise reduction.
Experience designing drive, interface, or impedance-matching circuits for transducers, actuators, sensors, or other electrically driven hardware, with an understanding of how electrical loading affects system performance.
Ability to take a PCB from schematic through bring-up and systematic troubleshooting.
Proficiency with oscilloscopes, signal generators, and relevant impedance, network, or spectrum measurement equipment.
Experience using Python, MATLAB, or similar tools for instrument control, data analysis, and test automation.
Ability to translate ambiguous requirements into practical experiments and clearly communicate findings across engineering and scientific teams.

Nice To Haves

Experience with focused ultrasound, neuromodulation, neural interfaces, bioelectronic systems, or other therapeutic or diagnostic medical-device technologies.
Multichannel or phased-array systems, beamforming electronics, and precise phase and amplitude control.
FPGA, microcontroller, or embedded firmware development for waveform generation, timing, and system control.
Low-noise receive electronics, transmit/receive switching, or ultrasound signal acquisition.
Experience with system characterization and calibration, such as hydrophone measurements, acoustic field mapping, electro-acoustic calibration, or analogous measurement methods for other sensing/stimulation modalities.

Responsibilities

Design drive, control, and interface electronics for neurotechnology and medical-device systems, including waveform generation, power amplification, impedance matching, sensing, and transducer or actuator interfaces.
Develop analog, digital, and mixed-signal circuits, owning schematic capture, PCB layout collaboration, board bring-up, and debugging.
Translate application and experimental requirements into electrical specifications, including operating frequency, output power, timing, duty cycle, channel synchronization, and sensing requirements.
Integrate transducers or other stimulation/sensing hardware, power supplies, embedded controllers, sensors, and software into working prototypes.
Build automated test setups to characterize electrical performance, transducer loading, efficiency, thermal behavior, and repeatability.
Partner with acoustics specialists to correlate electrical measurements with acoustic output and identify the causes of performance variation.
Implement monitoring, fault detection, interlocks, and protective circuitry appropriate to the device’s intended use.
Document design decisions, test methods, and verification results; contribute to risk analysis and design reviews.
Work with suppliers and manufacturing partners to improve component selection, assembly, testability, and reliability.